In this case, I use image mobility express and later use lwap when did upgrade with both ios always output this message and I was opening a case with the tac. and told me this problem with the hardware. Best regards.
Forum Posts
Hi. We have a 2700 autonomous AP configured to allow domain users to authenticate access to the Wireless Lan. To connect to the wireless the users enter their username/password or tick the "Use windows credentials" box which prepopulates the fields...
Our Vulnerability Scanner says that the cisco AIR-AP2802I-E-K9 is a High Risk.The Reason for that is that the process Lighttpd is unsecure. Lighttpd is from a another vendor. When you follow this link you can see that the vendor already fixed this pr...
Good day i have a problem which is rather weird. i configured web auth (internal) using lobby account to create passwords for guests. however when i test only phones pass the auth stage and have access to internet. difference now is i have tested 2 l...
I need to take WLC backup using Cisco Prime
Hi! We have wifi network based on wlc5508 and 2702i ap everything works well except max client speed. Only 2 mbps of download/upload is availaible for each client, and there is no any qos/limits configured on controller neither uplink router. We have...
Dear All, Here is my issue, Firstly, i plugged the AP 2702i to the switch port model 3560G using RG-45 cable. When i logged into the Ap through the Web Browser, i saw this message as mentioned in the subject title.At the same time, i touched the AP f...
Resolved! Cisco 2504 controller not booting
SYS and ALM LEDs on steady amber when powered. Please what could be the problem with the controller?Controller does not load any startup config.How do I make the controller boot?
Hello folks, I'm wondering let's say I have a switch that I can access remotely only. The switch is IP address is configure below: switch1# ! int vlan 6 ip address 192.168.6.5 255.255.255.0 ! !int vlan 120 ip address 192.168.120.5 255.255.255.0 ! i...
Hi guys, I am planning upgrade of a pair of wlcs in HA. 5508. Currently 8.2.166.0 version and upgrade to be to 8.3.150.0 (which is MD one recommended by Cisco). I found a link in the community > https://community.cisco.com/t5/other-wireless-mobility...
Good morning mobility community, I am trying to figure out the best way to prevent 11ac clients (Lenovo X1 carbon 6th gen running Windows 10 x64) from connecting to 802.11n on a specific SSID. I have enabled client band select on the SSID to make th...
I cannot find anything quite like what I am describing in the forums or elsewhere so forgive me if this is old or there is a solution available, I could not find that. I have configured a web login page, see attached for config.For security, Layer 2 ...
Experts, We are doing a deployment where we need to cover/provide Wifi coverage for outside areas such as patios and we are planning to use a mix of 3802e plus the air-ant2566p4w-r antennas. Although the questions i have are: What would be the prefer...
Hi, I've got 9 2802i access points setup using mobility express that works quite well for the most part - on average we have 170 devices connected and working properly. We are using ME ver. 8.8.120 However, we are regularly having trouble with device...
Hello Experts, Of the two available options listed below for the Wireless Integration in SD-Access, I need to proceed with CUWN Wireless Over the top.1. CUWN Wireless Over The Top (OTT): SD-Access Fabric is just an IP transport network and wireless i...
