Wireless

Dear All,    I have  AP's on the same subnet of the controller, however the AP is not able to join the controller although it is pingable from the WLC  and and it gets its IP from DHCP properly, I have the following logs, please help! spamApTask2: Se...

Dear all, Please, need your advice about this,my user ask me to change the wlc configuration to 5 ghz only with n/ac only.they said their end-points (smartphone and notebook) are support with n/ac and 5 ghz.what the impact if we deploy this configure...

I have configured my LAP 2700 with Flexconnect. Control part is working fine, but i would like to route my Data traffic via WLC. Is it possible? Can we still force it to go via WLC?I know it defeats the purpose of flexconnect, but that's my requireme...

Hi, I need to purchase one AP Aironet 1560 Series and I have WiSM2 WLC in my network, I need to make sure that WiSM2 WLC supports and compatible with Aironet 1560 Series, thanks 

Hi all, I have been curious on how we are able to limit a Wifi access time of users. For example, a guest user is only allowed to access Wifi for 2 hours. I'd also like to know about setting up one-time Wifi password.Is the combination of Cisco WLC a...

We currently have over 200,000 rogue APs detected on Prime. In order to see if any of these APs are wired to our network, I'm wanting to use APs in rogue detector mode. I've seen in some documentation that this can be implemented at the access level ...

Please note I have been given responsibility for this but no training.1) I have a AP which does not responds to the controller. I think the IP is wrong since it doesn't respond to pings (but the others do). How do I change the IP address?2) I can ssh...

Cisco Aironet 1600 / 1700 series support CleanAir Express. Newer model like Cisco Aironet 1800 series and Cisco Catalyst 9115AX/9117AX support Spectrum intelligence Can someone point out what is difference between CleanAir Express and Spectrum Intell...