Good afternoon,I'm trying to set up this AIR-AP1572EAC-BK9 AP and while it appears to see our WLC (5508 model) it gets stuck at this step as listed in this article: https://community.cisco.com/t5/wireless-and-mobility/cisco-1570-outdoor-ap-not-regist...
Hi, I am currently using WLC 9800 with AP 9120. When I upload a file via ftp to a server using 1 laptop, the upload speed was around 60MB/s. But when I am using 2 laptops to upload to the same server, the upload speed was shared. Laptop A got around ...
Dear all, I am trying to validate guest portal certificate through OCSP SwissSign server. I have pre-auth ACL, allowing communication towards the server and OCSP configured on the WLC, but still no reposponse from the server.(Cisco Controller) >show ...
I am having this mobility express controller where software is 8.3 , i need to upgrade to 8.10 , i have done upgrading to 8.10 two times but after rebooting still i am seeing the same 8.3 software only , I came to know that you cannot directly jump t...
Hello!I've been experimenting around with the newer 9800-CL vWLC appliance. I have a sole 3702i connected to it. I cannot for the life of me figure out how to get it to exceed 300Mbps (iperf3 and speedtest.net). I've tested both on a Windows laptop w...
Hi,I am looking for advice regarding remote High Availability for the devices within the Subject Line. Basically, a Customer recently purchased a competitor and our Company was asked to Co-Located their infrastructure into our Data Centres. This has ...
Hello all. I am running some older 3500i access points that I received from my organization. I set them up in autonomous mode. I have a full gigabit internet connection as well as hardware and cabling. As of now with my current configuration my downl...
Hello, I'm running a C9800 embedded on a C9115AXI AP. I have multiple different sites I'm deploying access points (C9115AXI-B) at. I have the policy configured so that if I create an open network, I am able to connect just fine. However, the minute I...
Team how many possibilities are there if we get DTLS connection issue.
Team I don have any radius server I want my AP to be worked as a Radius so that it can work local authentication. Is this possible .?
Howdy I have created a template in Cisco Prime to RESET the access points model type 1815W who are connected over FlexConnect but even that Cisco Prime output says that the access points have been rebooted, they are not actually rebooting and on the ...
Hi everyone, We have two different Cisco WLC 8540 located in different Cities ( City A and B ). Actually we have problem on APs which is registered on City B WLC. To make sure the problem is based on WLC, we connected two 2802i APs to same cisco 2960...
Team can anyone know below ans plz let me know. SSO HA is possible over tha wan, I mean to say my one wlc is in delhi and other is in Mumbai. Plz let me know
Dears, I had formatted the flash. So now I do not have RTOS installed on my WLC.Please i need a RTOS to install first . any one can help me to download RTOS image files to recovery WLC 2405 Thanks,Best Regards,Anton Girgis
Hi Team, I have a couple of questions: 1) I have a Cisco 5508 WLC running 8.0.140.0 code that I'm running with mix with 3702I and 1131ag AP's. I need help to find the most stable firmware for the AP running lightweight. 2) I have a Cisco WLC runni...
