XR OS and Platforms

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Take

 

Forum Posts

Ok - I'm trying to get a egress policy to work on a NCS 5501-SE Get this error, been reading the documentation- not quite sure what is going on. NCS is on 6.2.25       Error: RP/0/RP0/CPU0:XXX(config)#int te0/0/0/0 RP/0/RP0/CPU0:XXX(config-if)#servic...

When doing multi-hop async BFD sessions on ASR9K, the following restrictions / caveats are noted:1.  HW-offload is not supported2.  LC CPU which hosts the session is randomized according to line cards listed under 'multipath include location X/X/CPU0...

James Jun by Level 1
  • 1043 Views
  • 5 replies
  • 0 Helpful votes

Hello,In previous post (https://community.cisco.com/t5/xr-os-and-platforms/asr9000-forwarding-latency/td-p/2708349) back in 2015, it was identified that Typhoon to Typhoon forwarding latency on ASR9K is estimated to be around 15usec. Is there such fi...

James Jun by Level 1
  • 565 Views
  • 0 replies
  • 0 Helpful votes

We have RMA'd an ASR1001-X and ASR920-12CZ-D.  Both these units had 10G licenses that we purchased and need to put on the new units when they arrive - we need to transfer the license over to the RMA replacement units.  Is there a link on how to do th...

PK99 by Level 1
  • 1203 Views
  • 6 replies
  • 0 Helpful votes

On ASR-9904 Chassis with RSP5-SE.  I was under the impression that the RSP - Chassis combo could support 1.8T per line card.  However, when a A9K-8X100GE-TR is inserted, I get RATE LIMITED message. %FABRIC-FIA-1-RATE_LIMITER_ON : Set|fialc[4762]|0x10...

PK99 by Level 1
  • 888 Views
  • 2 replies
  • 0 Helpful votes