Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Friday, January 17, 2025 through Friday, February 7, 2025. Our colleagues Alex Guckin, Bryan Fenlason, Jason Wiatr, Zuhair Bedwan, Daniel Angelini and Jignesh Sh...
Our MSP recommends the DNA Essentials license. I've recently taken over and it's been renewed a few times. I see this is for Catalyst Center? I'm looking into how I can use Catalyst Center to see if it's worth it, (we're a small shop with 6 stack and...
Hi Everyone,I am need to transfer a file in DNAC and trying to used Winscp but unfortunately I am getting some error messages like Bash is recommended. I change the shell setting to Bash but still no luck. Can someone please kindly advice or give som...
Hi,We are planning to have two geographically separated sites, but they will be connected to each via dark fiber,Site A has two border/control nodes and several edge nodes behind it, we have fusion routers connected to this border/control nodes which...
Hello how we can to create isolate LAN or network access for few computers in ISE and DNAC environment. Cisco DNAC center is managing Trustsec security group . any documents or something to get help .. Guyzzzzzzz please help.
Hi All,Anyone know what is the DNAC Virtual Appliance requirment like RAM, vCPU , Storage etcThanks
Trying to find out what replaces the "magctl rbac external_auth_fallback enable" command on 2.3.7.0 and if it's still needed. Generally looking for any CLI information on 2.3.7 since it seems to have changed.
Hi, I am trying to find any explanation on the DNA center device interface status refresh mechanism. Customer complained, that in Provision > Inventory > particular switch > interfaces > Ethernet ports view, the dispayed port status does not match to...
Hello,We are configuring virtual CSR8000 over AWS infrastructure, and have configured IPSec tunnel for voice traffic.Tunnel is configured with Public IP tied to physical interface, and RTP endpoint tied to Loopback interface. With this setup tunnel d...
Hello, I've set up a simple network in packet tracer and I'm trying to limit one of the devices to http and https traffic only. I've made this access list:ip access-list extended Guestlistpermit tcp any any eq wwwpermit tcp any any eq 443deny ip any ...
Hello! I have a Cisco C6807-XL running s6t64-adventerprisek9-mz.SPA.155-1.SY7.bin.On this I have a standard ACL with a lot of denies on various malicious hosts. This is the end of the ACL: 1414 deny 185.220.100.254 1415 deny 62.233.41.1 10000 permit ...
Dear Community,I am using a Catalyst 3750 V2 switch and have successfully connected to the DaloRadius server. I can log into the switch with the users I created in the Radius server without any problem, Now, I want to grant or restrict access to the ...
Hi,I wonder which is the best way to monitor our DNA Center appliance. We have all our networking infrastructure monitored and we want to have DNA Center also under this tool (from SolarWinds). We usually monitor using icmp and SNMP. Is it possible t...
What is the significance of arp table in 2960 @switching
HiCan I jusy clarify some backup information please? The automation only backup is what you would restore if your cluster went awol and you are recovering all your fabric info? Device configs, hand offs, port allocations, L2/L3 VN info, SGT matrix ...
Hi GuysI have a problem where a few devices that was listed in my inventory was deleted and I'm not able to rediscover it. I have tried to add it but I get the following message. "NCIM11003: Device with IP address 192.168.11.139 already exists in inv...
