Hi ThereI'm trying to check the current version of elpd. I've tried sh version module 1 elpd, as per the release notesbut I'm getting an error!any suggestion please
Hello, I currently have N5K-5548UP running kickstart and system 5.0(3)N2(2). I can not just upgrade to the latest suggested version 7.3(5)N1(1). Currently there is a L3 module installed, model N55-D160L3 Daughter Card with L3 ASIC. Is there an upgrad...
I have a vPC between a 93180 and an ASR1002 that im not sure is configured correctly. From the nexus switches I see that the port-channel members are in the I (individual) state and show lacp counter shows no received PDUs. It seems to be functional,...
Hi All, We have kit at 2 DC's with Nexus 2 different vPC Domain's. We have say vlan 50 at 1 DC and vlan 60 at the other, I create vPC trunk on 2 DWDM links at both sites and allow both vlans at each site.. My question is which is best way to route tr...
I have a data center design related question. I hope I can get some feedback. I have a medium size setup. My primary data center has a pair of Nexus 9508 in NX-OS mode. It is running vPC and provides layer 3 functionality as well. There is compute an...
Hi All,i have confiugred two pair of OTV in my nexus devices DC1 and DC2 . DC1 = two devicesDC2= two devices .. i could see the three adjanceny in every otv device.but show otv site is showing partial .. site vlan is properly configured .still the...
I feel I have configured this correctly but the interfaces are still showing 1500 MTU. First off, I know that the switch has a default system MTU of 9216. I did set that manually at first, but realized it wasn't necessary so I removed the configurati...
I have a data center design related question. I hope I can get some feedback. I have a medium size setup. My primary data center has a pair of Nexus 9508 in NX-OS mode. It is running vPC and provides layer 3 functionality as well. There is compute an...
We are in the preperation to upgrade the N7700 switches from 6.2(12) to 7.3(3)D1(1).What would the best path be?Would that be 6.2(12) ISSU upgrade to 7.2.0D1.1 and than to 7.3(3)D1(1)?although multi-hop ISSU is not supported, would this mean that a r...
Hello everyone. I am attempting to verify configuration inconsistencies between a pair of 5k's in a VPC pair. I am hesitant to perform a config sync as I am not sure the last time the configuration was sync'd and do not want to break anything. Is th...
Hi There,We have two Nexus 5672's and are using 40G to 4 x 10G breakout twinax's. We've managed to configure the breakout fine and have had trunk ports up and running.I was trying to configure non-switched routed ports on one of the configured breako...
Hi all,We recently acquired some 2nd hand Catalyst 3560-X Series 48 POE (with C3KX-NM-10G Modules) but the previous owner did not wipe their configurations. Following this similar community post - https://community.cisco.com/t5/other-network-architec...
I am looking for Cisco Nexus 3048 Switch.May I ask about the following features, are they supported and included by default or need to pay additional software/license or not supported at all:- OpenFlow 1.3- SDN Tech.- VxLAN...
