Hello,I was wondering, if someone could please advise on the MIB OIDs required to install on NMS to receive and process SNMP Ennv Temp Traps of NXOS [9k,5k, and 2k]. Thanks,Martin
Hello,I was wondering, if someone could please advise on the MIB OIDs required to install on NMS to receive and process SNMP Ennv Temp Traps of NXOS [9k,5k, and 2k]. Thanks,Martin
Dear Community Members.,I need heads-up on setting up cisco UCS6248UP 10gb fibre switch to interconnect with Routers , Switches and servers in the Data CenterThe device is actually refurbished . Regards
Hi, I need to configure vPCs on nexus 3232c my question is: How must distribute the phisical ports to the vPC? should do a vPC between interface 1/1 & 1/17 or interface 1/1 &1/2? How are the ASIC´s distributions 1 slice to 16 ports, 1 slice to 8 por...
Hello to all colleagues in the cisco community, today I request help during the following scenario:1) I have two data centers connected by OTV under Nexus 7k IOS platform (n7000-s1-dk9.6.2.22). Under four devices.2) I have extended vlans between the ...
Hi, i have tried to configure Netflow on a Nexus 9504 Switch, if i try to configure "ip flow monitor IPv4_NETFLOW input" on a vPortchannel i get the Message "ERROR: Monitor IPv4_NETFLOW can't be shared under both L3 interface and L2 interface" Config...
Hello all,I have several questions regarding vPC fast-convergence option.1) At this moment I found documentation regarding this option only for nexus 9k. Is it supported by nexus7k? If yes, since what release (6.2(16) does not support)? In the config...
Greetings, So we just had a situation when placing a set of ports from a VDC to another VDC caused a major crash on all the VDCs except the dafult one The ports were originally on VDC A, where they didn't have any configuration, so we have no reason ...
Hi everyone, We want to upgrade our spine and leaf switches from nxos.9.3.8 to nxos.9.3.10.bin but we can't find any information about EPLD in release notes for nxos.9.3.10.bin. Should we continue with EPLD for 9.3.8 or should we go up to another ve...
Hi Team,Narasiman here Cisco ID CSCO11687982 I couldn't track my certification in portal, Kindly assist me where to find my certification history.My previous certifications all are expired and If I want to do CCNP Data center DCCOR(350-601),DCID(300-...
Is Cisco changing the Nexus architecture by replacing the N2K-C2248TP-E with the N9K-C9348GC-FXP ?
Hello together, I have inserted the Expansion module N5K-M1008 in the Cisco Nexus 5010.I would like to set the ports with the command: #Slot 2#port 1-8 type ethernetThen Comes the Output: ERROR: Module type doesn't support this CLI Can you help me? ...
Hi, I have 2x 3048TP which I use for redundancy. Today, after moving them, the 2nd one did not start. I cannot see any output using the console cable (I can see on the switch which starts with same config). What happens is that every ~12-15s the blue...
we heard most of the time that internet traffic is backhauled to Data center ,what is meaning of that?and there is local internet breakout then what is meaning of that?why do we send traffic to Data center?
Folks, Last few days i am searching for this answer on google but i didn't get any satisfied answer so thought let me ask here. I am running small spine-leaf EVPN+VxLAN and i want to use arp suppression to reduce my broadcast. I have couple of VNI wi...
Hi, I'm doing a lab in Eve NG and I downloaded the image of an NX-9k but I'm trying to configure a fabric-ext and it doesn't let me perform the "install feature-set fex" action.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Subject | Author | Posted |
---|---|---|
09-09-2024 04:42 PM | ||
08-30-2024 08:33 AM | ||
06-14-2024 06:10 AM | ||
06-12-2024 07:09 AM | ||
06-05-2024 03:06 AM |