IP Telephony and Phones

Hi All,I just would like to have some expert opinion on the probability of using IVR through Unity Express and then calls should route to Call Manager.For example, If we have a Site with 2800/2900 ISR Router with Unity Express Module NME-CUE and Cisc...

                   In my lab setup have two seperate 1760 CME 4.1 routers serially WAN'd to a 2620XM router using RIP, that has the Unity Express NM-CUE 3.1.1 module in it. The 2620 is just doing the voicemail and routing between the two CME's, no ca...

HiI have spent 2 days behind this little issue and still cannot figure out the catch. I have CISCO3825 with IOS c3825-adventerprisek9-mz.151-4.M4.bin and cme-bacd-3.0.0.2. I just need AA and no need for hunt group. here is the config:dial-peer voice ...

Hi,We are facing a problem in our production CUCM 6.After the power shutdown neither the Pub or Sub is doesn't work the Pub is asking for recovery disk "which is not available in our stock".And the Sub is running but I couldn't access the cm administ...

I have installed an AQM version 2.6 with CUCM 7 and UCCX 7.I have followed the instalation guide but I have some problems, I had some logs from Event viewer but I haven't found any information to fix them.Logs:RecordServer: The description for Event ...

Hi, i want to see whats the easiest solution to generate a call report from a cisco telephony. I was trying to generate it from the cli, but i just cant fin the way to do it.I will apreciate your answers.

Does anyone know how to find the manufacture date of a Cisco IP phone based on its MAC address of Serial number?  Is it the same as with routers & switches?

Hi,I am facing issue with my cisco unity module (NME-CUE). My router (2911) rebooted accidently and it boot with the IOS 15.2. after that my voice mail system gone down. In 15.2 it is not taking command for integrated service engine. Now I have reloa...

Hello,From debug isdn q931 what means the following:        Cause i = 0x80E46C - Invalid information element contents        Call State i = 0x06When I call outside, the calling number is not transmitted.Thanks

Hi Everyone,I have Integration of CUCM8.5 with Microsoft Lync 2010 through sip trunk (CUCM_Lync). currently enterprise-voice-service-enabled-users in Lync Server are able to call / dial other lync clients and IP- Phone extensions simaltanously. CUCM ...

I am upgrading from CUCM 6.1.5 in a VM Workstation Lab environment in anticipation of receiving my new hardware. I am trying to download 8.6(2)SU1 from Cisco and it says it should be 4.4gb but I only get 437mb at the completion of the download.. Is t...