IP Telephony and Phones

Please let me know what is the maximum number of particicpant supported in conference call by 6921 & 6941 IP phones.

Hi we have IPCCE vers 7.0 installed.We installed CAD 7.2.1 successfully.While trying to open Agent CAD we have the following error message (please see the image attached): Unable to login, some reasons maybe:- You entered an incorrect ID,password or ...

I have a customer that opted to go with a 4-digit numbering scheme, rather than a 5-digit and they have nearly depleted the available non-DID extensions for an upcoming phase of rolling out CER. They want to do approximately 1300 ERLs (zones) and ha...

This is odd the telco is sending in the calling party number minus the leading 0;Nov 13 14:25:57.378: ISDN Se0/0/0:15 Q931: RX <- SETUP pd = 8 callref = 0x0002 Sending Complete Bearer Capability i = 0x9090A3 Standard = C...

This is said to be a feature of the UC500 series system but does any one have a document or details on how to configure this great feature??

I have CCM 4.1 , 7970 IP phones and one Cisco 4506,one EPBX with analog phones in my network. I want to integrate these so that internally anyone can give a call from analog to digital and vice versa.My concern is what extra device is required for th...

Dear all,E1 flap during the past last 3 weeks, and you recommended me this command:network-clock-select 1 E1 0/1/0It looks good as this command made 0 Slip Secs & 0 Errored Sec.But, E1 still flap again, if i can increase the priority again from 1 to...

Hello,I've been browsing through cisco.com but I can't find any documentation about what the Integrated Service Engine exactly does and is used for. Could someone explain this to me? Or point me to some documentation about it.Thank you,~Grant

Is it possible to have endusers manage the openingtime of their script? We don't want to edit the script everytime when they close early. Is their software available so they can manage this themselves?We are using Cisco Unified CM 7.1.2 and Cisco Uni...

HelloI'm trying to configure SIP on CME for the first time, and I can get phones to register, but not communicate with gateway. I get disconnect cause 38, I suspect I'm missing something from the config. Can you point me in the right direction.Conf...

I'm trying to use the queuing feature in Attendant Console but am having a problem. When I check the "Queuing Enable" check box, CUCM queues calls and does not send to the "always route memeber" even though I have no ATT Console users logged in. ...

hi,a callmanger with ver 4.2 is working with witness 7.7.1 , the cm will be upgraded to 7.1 , will the witness work or not