IP Telephony and Phones

Dear Friends I am trying to connect to an ISP throught the ATA, we have CM 6.0 and PRI Lines, i have reduced the speed of my modem to 9600 but still i get an error "THE REMOTE COMPUTER DID NOT RESPOND" voice calls are ok but dialup is giving me issue...

We have five queues in IPCC Express.We have one IPCC Server and one Call Manager. What would cause the MOH to cut in and out when it is played in some of the queue's and not in other queue's?

Hi All,I am using:* Cisco 2851 (revision 53.51) with 765952K/20480K bytes of memory.* CME Version 7.1* CUE Software Version: 3.1.1* 2800nm-spservicesk9-mz.124-22.YB1.bin.* Different favors of IP Phones CP-7942, CP-7937, CP7971.IDD calls disconnects b...

Would anyone be able to point me to the right place for documentation of an upgrade of call manager 6.1.2.1000-13Many thanks

Hello,What is the meaning of CTI port? and when we should use?Thanks a lot.

Can a single CUBE gateway support two separate SIP trunks to the same provider?There will be two separate paths to reach the provider, one for each trunk. One routes via the LAN to the primary MPLS circuit, and one will use a T1 directly off of the C...

HiHas CUBE the ability to map RSVP application ID's across call legs? At present the configured application ID's we see on call leg 1 are not present in the RSVP reservation in call letg 2.RegardsTJ

ok, my lab is down for the short term and I can't think this one through...Customer has CM 7.x, Unity 7.x and IPCC 7.x. On IPCC, I have jtapi call control groups configured for each trigger. When a call dequeues, the port information description wi...

Problem: When placing a call on hold, the other party hears MoH. If the same call is placed on hold several times, the MoH audio is supposed to resume at the point where it was stopped when the previous time on hold ended. Sometimes this works and ...

One of our customers has handed me a 7911G phone to configure. I know how to configure it, but i'm lacking the latest firmware. I need to download the 8.5SR1 version, bit as only a registered cisco partner, i don't have access. How do i go about obta...

Hi,How I can reject specific call from the PSTN in a Cisco Gateway 1800 (running Telephony Service CME)?Thanks

I have a fairly customized requirement to setup AA on Unity 5.0. Most of the rules end up routing to a specific extension. Currently Unity is setup for VM only.Any configuration examples or things to look out for would be appreciated such as what if ...

I want one extension (lets say x100 for example) to be shared by all phones. If a user answers the call and if a second incoming call comes in, I want all phones to ring again (including the extension that answered the first call). Is that possible?W...

I followed the documetation exactly to set a background image on a 7975G. The thumbnail images shows up fine but when I try to request the image I get a "File not found" error. I checked the syntax of the List.xml file and also reset the TFTP servi...

Is it possible to restrict a phones settings beyond using the "disable or restrict" settings? I tried the restrict setting and that locks out every option except user preferences however we would like to restrict the users from changing their backgr...