IP Telephony and Phones

Hello everybody, I have 2 x 2611 Cisco routers in my lab. I recently bought 2 AIM-VOICE-30 modules. When I insert these modules on the motherboard of my 2611, the card is not accepted. I have both the 2611s equipped with 16 FLASH / 64 DRAM and latest...

hi allI just want to know abt callmanager axl server..?Thanks in advanceNahas

Environment:CCM 6.1/Unity 5.0T1 PRI with 2851 routerRequirement:Customer has an 1-888 number. All calls to this number are sent to a T1 PRI in Head office, but their regional offices are across the country. Customer would a solution to route the inco...

Hi experts,how we can change the wirless regularity domain, we have trapeze access points which i cant see any SSID at all, so how i can change the wirless regularity domain from the phone it self. i dont have the USB CAble

I am attempting an upgrade from 6.1.1 to 6.1.2.I have not found any docs on the procedure, only release notes. Can anybody provide me with the doc or step by step procedure?Thanks

Hello,I've currently upgraded my phone system from version 4.1(3) to 6.1. The upgrade went successfully, however I have noticed one issue since the upgrade. Whenever a user with a Cisco 7940 phone receives a call, the first character on the caller ID...

If two external numbers invited to conference,fxo disconnect problems occurs after conference ends.Is is possible to enable only one external number included in conference?thanks

I think this is just the fact I do not have my iLO interface configured.Please let me know if anyone else has seen this and what it means.Following Error:At Wed Jun 18 15:07:26 EDT 2008 on node 10.250.50.1, the following HardwareFailure events genera...

Hi,I am preparing upgrade from 4.13 to 6.1, reading release notes, compatibility matrix, etc...I have a few questions, hopefully someone can answer:1. we have 6608 blade with Cat 6509 with Sup 1a. According this website, http://www.cisco.com/en/US/d...

Hello,I am trying to create a JTAPI trigger in UCCX 5.0 (using Call Manager 6.0) and I am getting the message...."failed to create cti route point and corresponding line on CM" I have already created 2 triggers previously and was successful. Please h...

Hey I am adding a second PRI to a router that already has a PRI configured and running.The second PRI will be trunked together with the first one using the same DID range.When the telco confirms that everything is ready on their side I want to test t...

i have installed the CCM 6.0 and i have configured the ip phone to be behind vpn tunnel, sometimes the ip phones freezes and the voice drops and also the softkeys dispalyed at phone screen disappears.What can be ?Thanks.