I need to change a FXO for a FXS in the UC520 is this hotswappable or do I need to power down first. Also should the UC520 seeit automaticallyor should I need to assign it? I am new to this so I value any help.
Guys,IS there a specific requirement that the prompts recorded in CUE 2.2 Auto-Attendant script have to be in the format - " G.711 u-law, 8 kHz, 8 bit, Mono" ? If so, is there any specific recording software which can create this sort of .wav file? I...
Hi,integrating a "dealer" system IPC MX via QSIG-E1 over MGCP into CCM4.1(3)when they seize a line, it sets up a call without digits...but when they wait too long (about 1 sec) they get unallocated/unassigned number.This is NOT the T302 timer, but ho...
Hi,I have 3 PRA circuits installed on one 3845 router. I want to send calls from certain numbers out to a specific PRA. Following the Cisco doc, I used answer-address command to match the calling number, then trigger a translation-profile that prefix...
HI, i have a CCM 4.3(1) working with 7945 and 7941 ip phones working, and a 2851 router with SRST, but when i see the ip phones supported by the SRST router, i only see other phones different. i have already configured the SRST but i does not work, d...
I have a UC500/CME 4.2(0). When a caller dials the main number and then is transfered to an extension, they leave a message if no one answers at the extension. When the person at the extension listens to their voicemail, it says that the call was f...
hello,i have configured the bri interface earlier, and it worked fine.Today, when i want to do the same thing, the card is down ISDN BRI0/1/1 interface dsl 3, interface ISDN Switchtype = basic-net3 Layer 1 Status: DEACTIVATED Laye...
Hi all,Is there a way to configure a speed/abbreviated dial in the CUCM User Web pages so that you can have an extension tagged on, and so that when you activate it, it will dial the number, #, pause and then add the extension. Is there a way to conf...
Dear all,Please I have a problem with my H.323 Voice Gateway. I use a cisco 2801 with VIC2 - BRI-NT/TE and FXO cards. when i debug isdn q931, i get the follwing error message:- *May 14 15:13:18.359: ISDN BR0/1/1 Q931: Applying typeplan for sw-type 0x...
My scenerio is i am using Cisco Call Manager Express Whenever ip phone boots it get registered to CME router and on the IP phone display it shows CME Query is can we remove that CME logo from the IP phone display.Users should not be able to understan...
Hi folks,Here is my topology:CCME4.2 => SIP trunk => ISP-SIP-ProviderIs there a possibility to suppress the caller number over the SIP-trunk (like clid restrict on the BRI-interface)?Thanks.Greets,Norbert
