I have a CME and a few Polycom SoundPoint 601's that we need to get up and running on the system. The model of the polycom is a SoundPoint IP 601 SIP.
I've searched the forums and have been steared in the right direction, but every config I've tried doesn't work in my case. I've attached the config.
There's really nothing too special going on with the config at this point, I'm hoping there's something little I'm missing in the config or even something on the Polycom I need to configure.
*** I forgot to mention the Polycom gets an ip address from my dhcp pool, but during it's boot says "Could not contact boot server, using existing configuration", the phone procedes to 'loading application' and then to processing configuration, but just goes blank after a few minutes. The only thing I can do from here is unplug it to reset it.
Is there a way in UCCE with using an admin script maybe using the email application in Call Studio to send out an email? I know in UCCX you can send out an email if the script were to fail but is there a way to do it in UCCE? Any help would be great!
Fun lab with Packet Tracer and running Cisco CME with 3 ip phones, 3 laptops, 1 switch, and 1 router. Fun lab with repetition. You will be able to test your phones and laptop for connectivity etc. Solution;see attached CME Packet Tracer L...
How to configure IP Address for Cisco Integrated Management Controller CIMC. The Cisco Unified Computing System (UCS) is a data center product composed of computing hardware, virtualization support, switching fabric, and management software.
QuestionHi Team,I just need to confirm if we change NTP servers on UCCX, will it affect the license on UCCX 12.0 ?Do we need to re-host after updating NTP?Already done on CUCM and CUC , and it didn't affect but not sure for CCX. Thank you ...