Metro

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

Hello, community. I'm trying to reproduce setup with two customers (R1 and R2), PE router (R3) and common services (R4).Here is configuration:R1: interface Loopback0 ip address 10.10.1.1 255.255.255.255!interface FastEthernet1/0 ip address 192.168.15...

Resolved! Cat6500 CAM flush

Can anybody comment this:sw-bbone(config)#vlan 1811sw-bbone(config-vlan)#end% Applying VLAN changes may take few minutes.  Please wait...sw-bbone#sh mac-address-table  count MAC Entries  for all vlans :Dynamic Address Count:                28633Stati...

Please advise if there is any Catalyst switch, especially small one for aggregation layer, with at least 256K Layer 2 MAC addresses support.

Hi All,do you have any idea why we receiving this below logs messages,We are getting the same on one of our 6509 PE , and as per the documentation I had increase the channel ip igmp limit to 1000, but it still coming. I couldn’t able to get any docum...

sajism220 by Level 1
  • 1290 Views
  • 2 replies
  • 0 Helpful votes

Dear All,we have two sites and we`r using on both locations and both fabrics MDS9124 FC Switches, CWDM-MUX8A  - 8-channel (1470, 1490, 1510, 1530, 1550, 1570, 1590, and 1610) multiplexer/demultiplexer with monitor ports and LC connectors) -The connec...

Hello.Just a simple question about the Cisco ME-3400 series.Are the SFP socket MultiSource Agreement (MSA) compliant?Can we use SFP transceivers made by other vendors in ME-3400 switch?Thanks

pbenin by Level 1
  • 2409 Views
  • 1 replies
  • 0 Helpful votes

Hi,My customer has a question, what is the limit for entries for the route-map for PBR that will be done in hardware? This applies to soft-4900M 12.2 (53) SG2. I need a reference to documentation.Regards,lb

Hi, Can ME 3600X provides 50-ms rerouting time upon link failure with MPLS TE/FRR?There are many failure detection mechanisms cause the routers to switch LSPs onto their backup tunnels:1.Interface Down Notification (When a router’s link or neighbori...

Hi, Can anyone help me for suggesting any good document / book for configuring B-RAS and Radius attributes. I need to configure B-RAS for IPoE sessions. Thanks.

Hello world !i'm looking for the right device to :centralized optical SFP distribution centralized vlan centralized routing centralized symetrique (in/out) bandwith management / vlandoes any one know  the good product  ??regards,

vpancisco by Level 1
  • 1192 Views
  • 1 replies
  • 0 Helpful votes