MPLS

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Forum Posts

Hi guys,We are in aprocess to implement the mpls l2 Vc on our network by replacing the qinq l2 structure in our field, for doing so we have to replace the present devices which takes some cost to the management.In the mean while, can i know what are ...

I have a trouble with ASR901,I have many vrfs work normally, then appears many logs in my console and vrfs stop working.Somebody knows how to fix this trouble?Sep 16 10:02:54.773:  pstorm_bcm_prog_label:1227: l3_egress_create failed. Label: 1775. Err...

j2cs_1977 by Level 1
  • 4190 Views
  • 11 replies
  • 0 Helpful votes

Can ANYONE help; I cannot get my EIGRP neighbors to sync up across the VRF-Lite/GRE tunnel between R2 and R4.When I apply the tunnel vrf DMZ to both tunnel99, both tunnel99 shut down automatically.Thanks for any assistanceBTW, I am trying to share ro...

fsebera by Level 4
  • 2880 Views
  • 3 replies
  • 0 Helpful votes

i am trying to redistribute BGP routes into EIGRP . On the router the routes are correct and leaned via BGP and given preference but when i check at Core switch the EIGRP is given preference . I have tried to give redistributed BGP higher metric but ...

mohikcho2 by Level 1
  • 916 Views
  • 2 replies
  • 0 Helpful votes

Hi,I am confuse in TE and Inter AS topics,please any one explain me these and give me easy material if have ????I found something for Inter AS option A,B,C but was tuff and confusing couldnt clearly understand allspecially where to use "send-lable","...

Hi Guys,Sorry for basic question. Can anyone please tell me show command to see all routes in all vrfs or in specific VRF where a specific RT is set. I think command "sh bgp vpnv4 unicast all extcommunity-list" can serve the purpose but then i will h...

yhameed81 by Level 1
  • 556 Views
  • 1 replies
  • 0 Helpful votes

Hello I am facing a strange issue and would be grateful to have any advice on this please.I have an existing setup where Site A and site B are connected within an MPLS setup: When I ping from Site B to site A with size 1500 it works no problemping vr...

Hi guys,I moved one pw from interface 9/4 to 7/8. It didn't work, so I moved it back to 9/4. interface GigabitEthernet9/4mtu 9216 no ip address logging event link-status load-interval 30 no cdp enableinterface GigabitEthernet9/4.1614encapsulation dot...

dfauluchi by Level 1
  • 1530 Views
  • 5 replies
  • 0 Helpful votes

Hi,Recently I came across new term known as "Enterprise VPN" . I am aware of L3VPN, but not sure about new Enterprise VPN. Could any one help me to understand 1. What is Enterprise VPN.2. How different it is from L3VPN3. And How to check if the curre...

Hi,I am doing lab on GNS and having a very simple scenario, but i am stuck somewhere...lab diag is attached....in MPLS clous OSPF is the IGP used... CE is communicated to PE through static routing.Problem : unable to ping LAN of R1 through R4(PE) eve...

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Unanswered Topics