MPLS

Hi All,Please see the below network diagram.Provivder 1 PE -----Provider 1 ABSR(NNI) -----    EBGP -----------Provider 2 ASBR ( NNI )   ----   -EBGP-------Provider 2 PEWe are facing one problem with this solution ie.Provider 2 ASBR is not allocating ...

HiRoutes are not installed in the routing table.Se the following output:                 core# sh ip bgp 0.0.0.0 vrf vrf_brukerBGP routing table information for VRF vrf_bruker, address family IPv4 UnicastBGP routing table entry for 0.0.0.0/0, version...

Dear all,I'm building an MPLS lab with 7600s and ASR1000s routers. Up to now, I already have some VPLS and pseudowires configured, apart from native IP traffic. I use OSPF for internal addresses (loopbacks and internal links) and iBGP for 'external' ...

Hello,In a MPLS L3VPN a have a site where two PEs and two CEsare sitting on a LAN where EIGRP runs.I've set up SoO (same community applied on both PEs)PE1!interface Vlan970 vrf forwarding ap1 ip vrf sitemap SoO ip address 61.2.100.7 255.255.255.0!rou...

Hi All,     I would like to know if static pseudowire is supported in Cisco 7600 ruters?Thanks,Sakthi S

Do the Cisco 7600's have an equivalent to Juniper (and Riverstone's) Administrative-Groups feature? I would like to do MPLS-Traffic Engineering based on the Administrative groups? I have tried searching this feature, but haven't found anything. Ther...

Hi,Can you pls tell me what the things /command required for fine tuning MPLSPls slaos share Cisco link if possible.we are running OSPF as IGP & MP-BGP in CoreBr/Subhojit

Hello.I can configure  SHAM links between me3600-24fs and they are up and fine . However, when I reboot me3600 the , after reboot  that SHAM's are down. The only way I can get them to come back up is to  remove the SHAM statements from rebooted me360...

Hello,Please help me understand what  is the value after the loopback IP address and  does it vary based on? in the case below, the number zero (0);- Peer LDP Ident: X.X.31.215:0; Local LDP Ident X.X.31.251:0Best regards,Mwandu

Hi all ,Please see the network diagramCE1--PE1--P---GATEWAY---INTERNET ROUTERIn PE1,P and GATEWAY we are using ospf and MPLS is enabled in all the interfaces.CE1-PE1 ospf is enabled.GATEWAY-INTERNET ROUTER BGP is running.we are originating a default ...

Hi,I've an issue about cef based load-balancing in the MPLS core in MPLS/VPN environment. If you consider flow-based load balancing, the path (out interface) will be chosen based on source-destination IP address. What about in MPLS/VPN environment? T...

Am having problem bringing up mpls l2vpn between asr9k and 7609 router . Below is my config. The interfaces are up, the vc working, but can't ping across.AS9K***********************************************************interface GigabitEthernet0/2/0/6....

        delete