MPLS

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Forum Posts

HiIam running PE-CE Routing protocol as RIPv2 for a MPLS-VPN. The RIP Multicast pass through a Switch and for some reason the RIP updates werent coming through so enabled neighbor command under RIP in the CE router and hence reeceived updates from th...

Hello everyone. I have IPSEC between two sites, and unicast OSPF (with neighbors). IPSEC works on VRF interfaces. Problem is - all traffic between sites encrypted, but not OSPF :-(. How can I fix this? Or OSPF over IPSEC isn't supported by VRF?3825-1...

shutikov by Level 1
  • 667 Views
  • 2 replies
  • 0 Helpful votes

Hi allCould someone let me know does 7600 with SUP-720-3BXL support full MPLS, MPLS-TE, QoS, ... on Gigabit Ethernet channel interface ?Which port interface (LAN/WAN, ...) does 7600/SUP-720-3BXL support full MPLS features ?And does 10GBASE XENPAR Mod...

If the CE of a MPLS VRF is not aware of the PE loopbacks is it possible for an end to end traceroute across the VPN network gear to fail?

galo by Level 1
  • 755 Views
  • 2 replies
  • 0 Helpful votes

Hi all,I need help. For days, I spent my time to check my config many times. So far, I still did not get the clue what happen to my config. I am setting up Inter-AS MPLS VPN, with VPNv4 eBGP session between ASBR. Both CE have their complete route bet...

Good morning: We have a router 7204VXR that it is sending messages trap of labels MPLS illegals. Do you know some form of detecting the origin that is generating this problem? as I can know that it labels has the problem? can I activate some debug...

antoniolv by Level 1
  • 620 Views
  • 3 replies
  • 0 Helpful votes

Hi,Please anyone can tell wheather Gig modules are supported on 3745 and if yes then how many? Also please tell which is the Gig module I could not find on cisco.com.And also do the onboard LAN ports support Multi VRF function ?ThanksNK

Hello,We are migrating an ISP network from using EIGRP to OSPF. Some of their networks are running on a VRF, so to make a smooth migration we need to run both protocols on the same VRF, is this possible?If so, are all the standard OSPF features avail...

aretsu by Level 1
  • 487 Views
  • 3 replies
  • 0 Helpful votes

Hi guysI desing an MPLS Network for an enterprise environment. Apart from seven VRF's for each departement, there will be a voice vrf for VOIP traffic. I was reading through different articels describing QoS for MPLS. My question: Because all VOIP tr...

m-ott by Level 1
  • 507 Views
  • 1 replies
  • 0 Helpful votes

We are planning a new mpls network with 10 backbone,25 distribution and about 100 edge routers. We will try to use as much of mpls features as possible,ie, L2VPNs,L3VPNs,VPLS,traffic eng., QoS, mcast, carrier in carrier etc.. Which one would fit bett...

m.erkul by Level 1
  • 371 Views
  • 1 replies
  • 0 Helpful votes

Resolved! Vrf Aware IPSEC

Hi i am trying something inline with title mentioned but i m getting stuck up in getting my vpnclient establish the connectivity with my IPE box which is 7206.i have tried establishing the dynamic ipsec with my 6513 box configured to accept the same ...

Hi this conf is VRF LITE + IPSEC. During the test we see the packets don't come back (from a different vrf) to interface with tunnel. We ping from one PC behind the tunnel ip sec (inside the vrf A) to router inside the vrf B (on the same PE). The pac...

Top Solution Authors