Network Management

Hi all,environment:LMS 4.21Solaris 10trying to schedule a Best Practices Network Discrepancy Report everything works find (reports could be scheduled)except entering a eMail-Address in Textfield: E-mail.Hiting the Submit Button results in nothing, no...

After some time LMS stops to refresh network topology (not changing colors for devices which lost/found). However, if I restart topology services devices are refreshed.Checked the processes. Everything is fine but there is a process named "1018". But...

I'm using this EEM script to shut down a port when a cable is pulled or port goes down for any other reason. It works to shut down the port but I'm facing the following problem1. If I attempt to re-enable the port manually it immedeately shuts it dow...

Hiwe have installed a new appliance of LMS 4.2.2 in our VmWare enivronment. The platform is running licensed to work with 1300 devices. We have approximately 500 devices in DCR, most of them are small switches ranging from Catalyst 2950 to Catalyst 3...

Is VSS supported in Cisco Prime Infrastructure 1.2?

Hi Networkers,I would like your help on diagonosis the NTP problem on a 6500 switch.I have configured a single NTP public server and three peers on Switch 'A' and two server and two peer on the 6500 switches with the following straight forward comman...

Hi friend,I have a problem with cisco network assistant to manager a WS-C4506 which has a cat4500-ipbasek9-mz.122-54.SG1.bin IOS version. The cna dont find this device.Thank.Marco.

Hello,I have a Cisco LMS 4.2.1 on a Windows 2008 Server R2 plateform and I would like to bakcup the configuration of my WS-C4503-E version cat4500e-universalk9.SPA.03.03.01.SG.151-1.SG1I create the job in Configuration > Configuration Archive > Synch...

Hi,I have a NPEG2 router running 12.4 (15) T12. There is a channelized E1 card (PA-MC-8TE1) inserted into the router. One port is configured for channelized time slots and remaining interfaces are configured for full line rate i.e. 2Mbps.While doing ...

Hi allI had propblem with  Device performance report of LMS 4.0. You could see picture below about the problem. How do resolve it ?Thanks

I started to train seriously in my lab, preparing CCNA exam, yesterday I played with the ACL, I configured to deny ICMP traffic, but I've tried to set it to default www and ssh, but it did not succeed, I have a 1841 router with 2 host connected, the ...