Hello folks,I've been advised to look for help here at NetPro forum by Cisco TAC engineers. This is the situation here with 80+ customer routers. They have two VLANs behind the router at every location/site and practically identical setup for hosts a...
Hi,Can somebody please help / advice us concerning the installation of CW LMS 4.0.1 on Solaris 10!The installation keeps on failing when it is checking for packages. Also the second time when we downloaded the software once more.ERROR: AddProperty ca...
Hi everyone,A customer reported that their router experienced spikes (high cpu utilization) and claims that it is caused by snmp polling of the Ciscoworks server. What must be done to confirm that it is caused by snmp polling of LMS? If it is really ...
Using LMS 3.1 in win 2003 SP2. Recently experiencing a problem, not able to fetch/push config for the n/w devices. I deleted and re added the device to lms and found able to perform the task. There was no connectvity issue during the problem. Will th...
Hi,I would like add an alarm to LMS when a power supply of some device goes down. For instance, when the power supply fails LMS send an email or something like that. How can do it?Thanks in advance
All,I'm having an issue with LMS 3.2 and the fact that it's not reporting bugs from the list of devices I have asked for it to check Cisco, I know for sure that these devices have bugs as some of the IOS devices haven't been udpated in atleast 3 year...
Dear fellows,I am unable to telnet to any device from CM topology view. I ran device troubleshooting on one of the switches and noticed the below which I thought could be related to my problem:Generic OnLine Diagnostics (Generic OnLine Diagnostics de...
Hello everybody,When trying to fetch vlan via RME on 4948 switches, LMS fail with the error message : "Command Failed TELNET: Failed to establish connection to 10.100.254.31 - Cause: connect timeout VLAN Config Fetch is not supported using TFTP".We o...
To all you SNMP script experts, By using SNMP, how do I send a "show" command to a switch? The command is: sh proc cpu sorted | redirect tftp://<IP Address>/filename.txt
Hello, Iam new to the group. I have looked around and found some reference to my problem but no clear answer so I thought I would post here.I have ACS 4.2 that is serving as my tacacs+ server for router and switch access. I am using windows AD for p...
There was a interface down in one of critical devices in the network.that particular log is not captured by the ciscoworks(DFM-alerts).any troubleshootin steps to find the issue.??? Thanks...Regards,Channa
Hi!I'm having problems with the Discovery of a Switch 4507R+E.I'm using the LMS 4.0 version and when I do the discovery, it finds it, however, when I want to see it on the Topology Map. It shows a "?" in the device but I can see the rest of the devic...
