Network Management

Hello,I'm looking to replace the UPS's we use in out network cabinets/closets.Ideally I'd like to use SNMP manageable ones that can be intergrated with CiscoWorks to send traps and notifications for test failures, battery failures, overloads, input p...

Hello,I am trying to connect my Ciscoworks servers to AD for users authentication. That works fine.The problem I am having though, is my users are from multiple AD domains in my company.How can I connect my LMS 4.0 (running on Solaris) to multiple AD...

Hi all,I would like to erase all the username configured on devices (catalyst ), and put new one. But the problem is that I've got about 500 devices, with different username.In the CLI (or with LMS) is there a command like "no username *all*" ?thanks...

I have two identical LMS servers running LMS 3.2 on Windows Server 2003 R2. Both manage the same set of devices.  I have setup a periodic sync archive job to perform weekly archive sync jobs on smaller sets of devices since this LMS server manages ab...

Welcome to the Cisco Support Community Ask the Expert conversation. This is an opportunity to learn how to install, maintain, operate and troubleshoot CiscoWorks LAN Management solution with Cisco experts Svetlana Radzevich and Geert Cober. Svetlana ...

When performing sync archive in RME, i always get "partially successful" for the switches. When checking the job details, it was successfull for the primary and running config but fails on VLAN. My transport settings were just the default, and then I...

Hello,We have problems with ANI Server on a recent LMS 4.0 installation, the process appears with the state " Running with busy flag set" (always looks like on the same state), and we can connect with the service topology pluging and I can see topolo...

I want to configure SNMP in PIX and have performed the specified commands, but its isnt working. Also i want to know which SNMP version i have on my PIXsnmp-server community TPrivatesnmp-server location NYsnmp-server contact ITsnmp-server host inside...

I need to remove old configuration from my LMS application and "cwcli config delete" seems to be fine. I have to questions about the command:1. are removed only the relevant files on disk or entry to database also ?2. is the the way to give to the op...