Network Management

Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Resolved! CDP Neighbors map

CDP Neighbors map in the Device Troubleshooting is very useful, How can I use it separately without open Device-Troubleshooting page or Topology services page?LMS3.2, CS3.3, CiscoWorks Assistant 1.2.0

After a Device Package update, I see the following procs left running:    root  8268     1  24 15:39:15 ?           1:11 /opt/CSCOpx/objects/dmgt/dmgtd.sol    root 10304  2006   0 15:51:01 ?           0:00 /opt/CSCOpx/bin/in.tftpd -s /tftpboot casuse...

yjdabear by Collaborator
  • 12 replies
  • 0 Helpful votes

HiI am a new user of Cisco Network Assistant. I got it to display the network of switches in the topology view. However a couple of switches are not displayed as linked to another switch (i.e shown as seperate from the network). Could someone please ...

raoul2341 by Beginner
  • 3 replies
  • 0 Helpful votes

I am trying to find the correct configuration for when modules from 4500 series devices are removed or fail an SNMP trap will be sent.So far I can not find any documentation or supporting command that will trigger this.The command on the 6500 series ...