Network Management

Hi,I am trying to sync archive for the devices that have never had their config's collected. When I try to do this I get the below error.DCMA0055: URN_NOT_FOUND : urn "JRM" : Not found !! DCMA0077: Could not create job. Check dcmaclient.log for more...

I'm having a problem adding WISM modules to CiscoWorks. Here is the output from the failed archive management job:*** Device Details for durhq1-cra-wr01 *** Protocol ==> Unknown / Not Applicable Selected Protocols with order ==> SSH,Telnet,TFTP E...

Hi,RME 4.1.1The software distribution job is always failing for this cisco 3750 switch.I tried to fetch a small text file on the switch from cw server to verify UDP-69 connectivity. TFTP worked fine for the test file.C:\PROGRA~1\CSCOpx\files\rme\jobs...

Hi All, I dont understand why UT is not discovering cameras connected to my access switches. There are aroung 300 cameras in the building but LMS not even finding one and also it discovered 20 hosts out of 250 end hosts. but IP phone it is finding co...

NEED HELP! :-)I made a baseline template that basicaly says: If you encounter an interface with a vlan24, apply a port-security mac-address sticky command. TEMPLATE FOLLOWS: In Conditional Block's SUBMODE:interface [#.*Ethernet.*#] CLI Command (of co...

We have a network of about 750 Devices. We have implemented LMS 3.1 as a primary NMS in our NW. Now we want to measure total downtime in a month through CW LMS. How to do that ?

Hi,Is there a way we an creat MIBs and we can link it with CiscoWorks to monitor the information it will provide?-Thanks

Hiis it possible to get notifications on port channel utilization but not on the physical member interface? i have a problem here: some of the interfaces i'm monitoring using DFM are member of the port channel, and i want only to monitor utilization ...

Hi,I need help, because I can't edit a Notification Group successfully because when I click "Finish" (after editing) it sends me an error (attached). Previous, I had stopped all suscriptions. After the editing and the error DFM is blocked so I can't ...

Hi teamI had open a post in lan switching for this particular problem and the expert from that forum has given the solution of embedded event manager so i need a help from this forum.The probelm defination is==Cisco 6509 (Core switch) connected to fi...

Hi All,I use this H/WSystem image file is "sup-bootdisk:s72033-ipservices_wan-mz.122-18.SXF5.bin"cisco WS-C6504-E (R7000) processor (revision 2.0) with 983008K/65536K bytes of memory.When doing snmpwalk using SNMP version 1 get response as follows:[c...

Hi,We are trying to creat more groups in CS and it gives an error as :"You have exceeded the maximum number of User Defined Groups. The limit is 200"Is that the max. limit or is there a way we can increase it?Or is it a Bug?-Please advise.