Hi,I have a management network that has 192.168.148.0/24 IP range. Also I use 192.168.148.0/24 (braked to small subnets) for L3 p2p connections. I use eigrp (AS 1) for routing these addresses. For routing between the other networks I use static route...
HiPlease advise how to configure Netflow on 4506 switche per interface. I converted the port to layer3 port with no switchport. But I can't find the command to enable for Netflow.ThanksNoom
Hi.What would be the best approach to do health check for Cisco devices ( routers / switches / firewalls / access points / wlan controllers / etcetera ).Any great tools or native commands to perform it?Please help.Tnx in advance.
Hi team,I need to install CWLMS3.0 and CSMP3.1 on WIndows at my client side. I asked for two seperate server from client for the same. Client is insisting to install both on the same machine, as it would be cost effective for him. Please suggest is i...
Hi,I would like to use the dcrcli to export devices in a script. To avoid the password I should set DCRCLIFILE variable. As documented :You can set DCRCLIFILE environment to point to the file where Common Services password is present.My question : Wh...
I am new to Cisco and a bit confused by IOS version selection. Does it make the most sense to upgrade to the most recent and stable IOS for a particular device? How about IPBASE vs. IPSERVICES vs. xxxx?
trying to configure netflow on a 7200 router getting this when i do a show ip flow export, not exactly sure what an adjacency issue is ? someone point me in the right direction 45 export packets were dropped due to adjacency issues
We have recently installed a new LMS3.0 CiscoWorks. I have run a discovery and can reach all devices except for our CAT1900 switches.They report back as:First Found by Module - CDPStatus - UnreachableI have verified that CDP is enabled on both ends ...
In the past I have found a couple of useful replaceable parameters. For example, I can use the archive subcommand "path tftp://10.1.1.1/&h-&t.cfg". This will facilitate saving the configuration to a TFTP and will use the switch or router Hostname-D...
Hi,I'm not sure what does a dotted line mean in topology services maps.I'm looking in the docs and it says they are links "not in network" but I don't understand this concept... is it a trunk?Thank you very much.
Is there a way for the Network Topology View to show Virtual-Access Links? I am using PPP Multilink with 2 T.15 interfaces and the links do not show up in the map. Maybe because it uses CDP, and CDP does not work with Virtual-Access links. Anyhow, ho...
