Network Management

LmS 2.5Common Services 3.0.3Campus Manager 4.0.4Cview 6.1.2IPM 2.6.0When trying to open topology service I get a message that it cannot connect to the Ani Server. I have reset the ani process and still get the message. Everything else in campus manag...

On my LMS 2.6 server, /var/adm/CSCOpx is a separate physical disk from /var, with the latter being very tiny in size. Is there any way to have diskWatcher keeping tabs on the real /var/adm/CSCOpx instead of popping of alerts on the nearly filled /var...

We have a number of remote branches (several hundred) connected via ADSL (using IPSEC tunnels) and I would like to simply monitor the up/down status of the connections from head office to each remote site.Can anyone recommend a simple, cost-effective...

I am trying to use Security Manager v3.1 to deploy the following configuration.Corporate Office with IOS Router - network 10.0.0.0/8Remote Office with IOS Router - network 192.168.1.0/24I setup the Remote Office with NAT so the users at the Remote Of...

Is there a way around the 10 device limitation when executing Network Show commands inside of RME 3.5?

After the upgrade to Campus Manager 4.0.9, all links are now shown as "not in netwerk" (red dotted line).Any help would be appreciated.Tx.

Hi There,Is there a way to log successful logins/telnet to the router?Say JoeBlow has access and telnets successfully to the router. I want to be able to do a "show log" on the router and see that JoeBlow logged in at this time and date. Is there a w...

Where can I get the TCL Library? I guess that problem "unknown namespace in import pattern "::cisco::eem::*" can be resolved with a help of the TCL Library.

Hello,I have a 3560G used as a router. This switch is routing packets between untrusted networks.I can connect to it using one of its operational IPs. But I am wondering if there would be a way to define a kind of management (IP or physical) interfac...

I have a Cat 6504-E chassis with a WS-SVC-CMM. The CMM shows red on topology map because LMS wants to use it's loopback 0 address for management. For some reason, the CMM can ping out but the loopback cannot be reached, not even fom the supervisor ...

Hi,I performed a local WIndows server upgrade from LMS 2.6 to 3.0. So far everything seems normal except for CiscoWorks Assistant.I can launch the CiscoWorks Assistant home page from the LMS Portal page just fine, but if I try to select anything und...

Hi all,Is using this dynamips / dyanagen & pixemu legal? As we need to use the Cisco real IOS >Any idea?Awaiting reply

Hi,On the DDV (dfm2.0.6, LMS2.6 on windows) I noticed also card information? Where does this come from? This family is just a 24 ports switch without card support. Problem is that these 'virtual' cards generates events OperationallyDown because this ...