Network Management

could someone provide me with the benefits of using rcp or tftp. I can't seem to find any information on why one would be used over the other (assuming that the device can do both).

Dear Expertise,After i install the security device manager, but is was unable to load the configuration page. it just prompt the screen and show the html script. please help.thank you.

We are installing LMS 251 on Solaris 9.During the CS 303 Install, we got this error message. What do you recommend, we should do? Proceed, Abort OR Uninstall?=================================================================Finished: Wed Jan 31 11:25...

It seems that older products which used to work with CW 2.2's RME have been poisoned to stop working. The RME>Software Management>Library>Add Images always bombs out adding images for the following older products;MSFC2 downloading 12.1(27)b.E (Hybri...

On CW 2.5 I have configured the purge of archive Mgmt. It does not work. After 15h the job finished with fail status. I have incresed the archive Mgmt fetch settings suggestet in the error status from the each device. Can someone help.

I have configured a 2600 as dhcp-server with this configuration:!username AccountRemote password PasswordRemote!ip dhcp excluded-address 10.8.0.1 10.8.0.200!ip dhcp pool RasPool network 10.8.0.0 255.255.255.0 default-router 10.8.0.127!ip dhcp-se...

Hi,I have LMS 2.5.1, and I need to add the 1240 access points to the topolgy map. the access points have snmp configured and the devices are discovered, but the devices are shown as unknown devices in the topology map but not with the wireless access...

What standard SNMP configuration is required on all cisco routers and switches for the CiscoWorks.

Ok I am really in need of some suggestions here. Part of our backplane is a 6509 which acts as the go between for a server farm to a collection of vlans. My manager wants a report of monthly uptime statistics for each specific port that a handful o...

Hi all, I have a small issue I hope someone can shed some light on. A number of the sites I help to support use ATM IMA bundles for WAN Access. Most of these are 3-5 T1s. The issue arises when one of these T1s goes down, we dont get any alerts via Op...

In IP solution center 4.1.1, some entities like "provider", "regions", "customers" and "sites" must be created in advance before running auto-discovery (v 4.1.1 no longer uses the file inventory.xml ).After discovering all MPLS VPN's ISC provides a m...

Hi All,Does anybody have any information on Cisco's support of the IPv6 mibs? The main mibs I am interested in are RFC 4292 ( routing ), RFC 4293 ( IP mib ) and RFC 4295 ( Mobile IP ). The information I'm looking for is wether the MIBs are currently ...

HI,all How to prevent bogus dhcp server in a same vlan with clients needing dhcp service from legal dhcp server connecting to Catlyst 4506Without disconnecting Ehternet Line physically.Please refer to attachment.

hi,I've tried to find some info on the subj. on CCO and looks like nothing is available. I need to connect a Cisco Works 2.6 server (Sun Fire 280R) to two switches in a datacenter in the failover configuration, Solaris has this multipathing function...