Hi I found something abnormal for RME Automated Action. Although I already disable the action, it is still sending out the email. Anyone has ever face this situation before? Is it something to do with database corruption? If still cannot make it ...
After we upgraded to native IOS on our 75-9's we now get a DFM trap IP Duplicate address everytime cisco works does a discovery, which is daily. These are addresses which are on point-to-point connections between core layer switches. Has anybody had ...
Please read the recent post for details.I have 6 campus mgr servers that are now all set to generate syslog messages to 3 different syslog servers that have the RSAC software installed. The 3 RME servers are, in turn, set to pull these syslog messag...
I have to trasfer about 500 configs from CW server to my PC (then to another server). I don't have access to the Shadow directory or cwcli. To many configs to use cut and paste from the config viewer. I appreciate you help.Mark
When CW does an automated acquisiton of devices on the network, I noticed that it does not list them by hostname but rather IP address and sometimes two IP addresses of the same device but different ports. How can i get CW to list devices by hostnam...
hi,i have just integrated all LMS applications to ACS, there are 2 issues currently in hand:1). Whenever i click on Acquisition tabs (Campus User Tracking), an "HTTP status 500" error is shown.2). Topology services of our VTP domain shows all devices...
HI frenz, I m very new for LMS. I know it is a very silly question. From which tab i can see that particular switches hav or hav not SNMP string. plz tell me.thnx
I have the following abnormal bahaviour of RME (LMS 2.5.1). After discovering and adding devices to DCR, I defined telnet community for each device (I add the user "cwuser" at the ACS and each device use ACS primary authentication). When I try to...
Hi, I am using LMS2.5. can anyone tell me how can i see devices details of my network? I wanna to know that which device has snmp string or which not? sothat i can fill snmp in that device.thanks
when i trying to config. LMS2.5 on window server, the server info shows this reportnetwork.pl*** Default servers are not available*** UnKnown can't find 127.0.0.1: No response from serverwhat it means ? it's shows FAIL no devices is populated in DCR ...
Our BBSM v5.3 is ready and working. I would like to have a copy (image) of complete BBSM server (with Norton Ghost for example) and daily database backup.For total image i know how to do but i am not sure for daily backups.It is important for me to ...
How to create a threshold for interfaces, then specify severity. say, 40 % of interface utilization will generate an alarm of minor, 50% major and 60% critical.
Serial line protocol goes down after 1minute if the other end which is connected to Nortel Passport is locked.This results a delay in redundant linkcoming up..Channelised E1 connectivity between Nortel passport at one location to the cisco 7206 rou...
Hello could you tell me where are saved the vlan.dat file of Catalyst switches?In the RME doc I have just found the following text:Archive and Restore VLAN Configuration FilesFor all Cisco devices that support VLAN configuration such as Catalyst IOSs...
I recently did an upgrade to my ciscoworks server I updated everthing with the cd's that cisco sent me. now when I click on the ciscoworks icon all i get in the web page is server not ready please wait.... its been like that for at least 24 hours. I ...
