Network Management

hi together,i'm trying to transfer an image file to a 2924xl using xmodem...another protocol, like tftp, can't be used caused by me deleting the old image :-(i tried to transfer the file with tera term but the upload to the switch didn't startnext ti...

Hi All, I was configuring Cisco works to sent out e mail alert automatically when there is a problem in the switch. but after configuring it. i only receive one e mail alert. i want to configure it to sent out alert e mail every 15 mins. how ca...

I am not able to capture view of Cisco 6509 FW service module & Cisco 525E firewall from ciscoview installed with LMS 2.2. Can anybody tell if it is possible to have a view of Cisco Firewall from Ciscoview.if possible, then how ?

RME 4.0 Device Credentials Check fails for C2924XL. Given credentials are correct.

When I run the Out-of-Sync Summary report, I get quite a few entries that when I click the diff icon I get a message that says no differences found. The only thing I can think of is that when populating the Out-of-Sync Summary report it doesn't take ...

Hi,I have 6509-E implemented in the network,When I tried reterive the reports from RME I cannot see any records.All other moduels are working properly(campus,device).Is it required to install any patches inorder to get the reports generated?Thanks in...

Hello, I have successfully instaled LMS 2.5 except IPM 2.6.During the installation I receive the following messages:Java(tm) Runtime Environment Version JRE 1.3.1(C) Copyright 1997-2000 Sun Microsystems, Inc.All rights reserved./home/telelink/softwa...

Running ITM 2.0 IDU6 on win2k. When trying to rediscover 2 servers, I am getting a "DataCollector request timeout (internal problem)" error message. What does this mean and is there a workaround?

I just got an email asking me to fill out a survey about:Resource Manager Essentials (RME) version 4.0 Campus Manager (CM) version 4.0 Device Fault Manager (DFM) version 2.0 Internetwork Performance Monitor (IPM) version 2.6 CiscoView (CV) version 6....

How can I upgrade ITM 2.0 to IDU 2?

In LMS 2.2 RME 3.5 IDU 11, I only find WS-X6148-RJ45V, but no WS-X6148-RJ45 in the list of Card Types in RME -> Admin -> Inventory -> Custom Reports. Is the list built "intelligently" according to what we have, or am I missing WS-X6148-RJ45 support i...

Is there a way to make changes via the CLI on a PIX and have it "sync up" with the AUS or Firewall MC?Thanks.

Hi, my CiscoWorks2000 (CDone 5th ed. 2.1) + RME 3.4 give me an diskWatcher popup with this message: {diskWatcher}: Available space is low on filesystem /. Check /var/adm/CSCOpx/log/diskWatcher.log for details.These are the details:F_SYSTEM AVA...