Network Management

Hello,yesterday I needed to reset my switch so I hold "Reset"for 30 seconds. From that time switch can't start. If I start switch, system light is flashing only.Tried to hold reset again, nothing happened.After about 15 minutes ethernet led turned on...

I'm trying to enable to HTTP Interface so I can more easily manage the device and not have to manually enter  commands of which I have not done out side the classroom in some time and would rather just do it via the web interface..  Relevant informat...

Hello Everybody, I'm configuration tacacs+ on nexus switches, but unfortunately something is wrong, or any command is missing. I would like to know what are the correct commands to configure this type of authentication. PDTACACS is running on ISE Che...

I have a cisco UBR device in network but when running snmpwalk with device it gives us OID not increasing error. Following is the output of error :- kumar@mng:~$ snmpwalk -v2c -c ****** pl-ubr-01 iso.3.6.1.2.1.4.34.1.3.4.20.254.128iso.3.6.1.2.1.4.34....

I am trying to perform a MIB walk on a device I have recently configured SNMPv3 on. I have configured my v3 view as follows... snmp-server view ALL iso includedsnmp-server group MyReadWriteGroup v3 priv read ALL write ALL access 1snmp-server user Myv...

I have previously been able to add Static Nat's with no issue, as recently as a few weeks ago. I attempted to to create an additional Static NAT and am now unable to create or delete Static NAT's, other configuration options seem to work. I currently...

Here is the SNMP configuration I need to make sense of. 1) mac address-table notification change interval 02) mac address-table notification change3) snmp-server enable traps mac-notification change move threshold4) snmp-server queue-length 305) snmp...

Hola buenos días, tengo un router Cisco RV340 que funciona perfectamente. El único inconveniente que estoy teniendo es que mientras esta el firewal activado no me deja entra en una pagina web del gobierno (Afip). Ya probé con varias opciones dentro d...

Do you have any public documentation for Cisco network monitoring tools pls? I'm looking for things like user guides and installation guides. Not case studies.