Network Management

Hi all,after I configured the global mail setting on my cisco prime infrastructure (I set the ip of primery SMTP then sender and reciever parameters) then I press on test button to send a test mail but it not send ??note that:I made sure all services...

Hello Everyone.I try to configure netflow feature in my Prime 2.0 but i have no success.When i deploy the template "Medianet Perfmon" i can select only two routers, my switches do not appear in selection pane(image attach), i need to capture the flow...

Hi to all,Which release of Cisco NCS Prime support the taking charge of  Aruba Networks controller ??

Bit of a netflow and Cisco newbie questio -Is it possible to setup netflow for a L2 non-routable vlans?I am running Cisco IOS Software, 2800 Software (C2800NM-SPSERVICESK9-M), Version 12.3(8)T7, RELEASE SOFTWARE (fc3)Config in question -!interface Vl...

Hi;Will Cisco UT Lite script (for Prime LMS 4.2.4) will support with windows Active directory and domain controller on Windows 2012?If yes can you please share Link, I try to search but unfortunitly I counldn't found. All document refere till Windows...

Hi,we are trying to install Prime NCS hardware  Appliance  for fist time, but during starting ncs service it gives an error writen below.isco-Prime-NCS/admin# ncs startPurging PurgeSAMPollerRecods{Fri Jun 21 08:28:03 UTC 2013} =======================...

Hi :I need the Cisco ASA5520 SYS OID for the LLDP protocol so that I can create the network connection between Cisco ASA5520 and the 3rd party networking device in this 3rd party network management management system.Can anyone help on this?I tried to...

Hi,I have been asked by a client to provide: "a week by week report on our daily bandwidth by floor ports usage including WiFi  port.This will be important for  capacity planning, usage monitoring to ensure we have enough bandwidth quality  of servic...

hi all,I have Cisco Prime Infrastructure 1.4 and I want to create Layer2 and Layer 3 Network Topology for my network as the one that was created using LMS.How Can I do that task using Cisco Prime Infrastructure ?????

I've been digging through Cisco's SNMP Object Navigator without any luck, so I'm turning to the masses to see if someone has an answer.I'd like to know if there is a supported MIB on the C3560G platform (for any IOS version) that will report the QOS ...

Hello,Is there a 32 Bit version of this eval?  I don't have a 64bit host available right now.   Can you point me to the 32 bit version if there is on?EVAL-CPNR-81REGCisco Prime Network Registrar 8.1 (Regional Virtual Appliance for VMWare)