Hi,I have been trying to complete a marked assignment using Cisco Packet Tracer, but I keep having issues regarding the connectivity test. It always tells me that my connectivity tests for 1 and 4 are incorrect, even though I have done the correct co...
Forum Posts
Resolved! Why my router doesnt work ?
Hi, Im trying to make a vpn connection behind a firewall. But before passing to vpn I wanted to test my routers which they dont seem to be working. For example laptop3 or pc3 to laptop 0 by passing through Router3.
We have 16 10/25G CSR-S and 2 9200L switchs. We want to use 10G but its doesnt work. Doesn't 9200L support 10/25G CSR-S ? What can we do?
We are currently trying to tie up redundancy using ISE version 3.2. Also, at the customer's request, forward/reverse registration is not currently in DNS. However, I set each other's IP and FQDN using the ip host command. As far as I know, redundancy...
Hi everyone, We have a cisco ISR4431 with version 16.6.7, and we want to upgrade it to 17.9.4a Is there any suggested path or we can do it directly? Thanks, Noemi
What are the remote access VPN licenses available for FTD 3100 series managed by FMC
Hi I want to get the model number of Cisco routers and switches and I am hoping there is a way to capture the model number from the command line and putting it into a variable for TCL or VBS scripting like the command "show snmp chassis" displays the...
Hello Engineersi am little bit confused of what is the IP address that i can remote access to it via SSH or Telnet in switch or Router is it (Interface VLAN) or even the (IP of physical interface)? And must be with same network pc to access remote sw...
hii i need help with hsrp configurations tho ive got the basics alr as seen in the above image, I've shut down the main interface g0/0/1 for r2. however, both routers have standby 'unknown'.^ r3 router^ r2 routereach sub-interfaces have their own vir...
Hello everyone. I'm working on a Firepower 1010 v7.0.1-84 in a test environment. To access the firewall dashboard, I need to enter the IP address 192.168.95.1.How can I change the inside IP address? I've been searching for several weeks and haven't f...
Hi everyone, We were try to change via cli the primary and secondary controller configured on a 9115 ap. While we were saving the configuration no error was shown, so we believed they were changed as we wanted. The configuration were shown still as...
Hi @All I need a solution to simulate the interface status to the below SNMP values(State) in gns31 : up2 : down 3 : testing 4 : unknown 5 : dormant 6 : notPresentThanks in advance!
Can we integrate FMC, FTD with ServiceNow directly?if yes please share supportive documents.Many thanks
I intend to have Frame Relay to connect 3 LANs in which the 2 branches are connected to the HeadQuatar (HCM). Yet I have just implemented the connection between HCM and the DN Branch and then I got stuck.(In these LANs, I also have a Firewall but I ...
Hello,cisco ISR4451-X/K9Is there a way that I can identify routes that are not being used to delete?We have hundreds of routes, and I believe there is a lot of dirt.
