Network Security

When I try to load anything to a sensor from Ciscoworks, I get the following message:Error importing configuration files from the sensor -Can not get the type of sensor. Remote process exit code unavailable I've tried to delete and add back the senso...

Dear all, Can PIX configure two default route with equal cost for load balancing? How about can PIX receive two equal cost of OSPF default route for load balancing? Thanks and Regards, mak

We have a 515PIX at our home office and small 501 at a remote office connected via an IPSec tunnel. VPN Clients terminate on the home office PIX using IPSec and the Cisco VPN Client.What needs to occur to allow the VPN clients to access our remote of...

Folks, I am very new to the IDS on the 6500. I have give it an ip address but can not make it ping the default gateway. How do i put the interface in the right vlan???Can i use a web based interface to collect logs or manage the idsm using a GUI.Than...

Problem bouncing throw a PIX.In my company we have a Hosted Rack white a PIX firewall. The firewall is mange by the Hosting Company.There say the following about my problem, white bouncing from the inside of the firewall:Firewall setup doesn't allow ...

I connect with vpn client v 4.0.3f to the pix 501 v6.2, however I can access resources on the remote lan only after I initiate some kind of connection from the remote lan to the vpn client (a ping for example).Could the fact that I don't get any dhcp...

IDS signature update not working on IDS-4215 via Ciscoworks VMS. IDS-4215 Cisco systems IDS version 4.1(4)S91. Trying to deploy signature update IDS-sig-4.1-4-S162.zip.The following error is been noted in the audit report:"Sensor update for LDS_SENSO...

Dear all,I have a cisco1700 series route which contains two ethernet ports.I don't want to use serial ports.I have a broad band connection(i.e. through smart bridge). One etherent is connected to smart bridge. & other one to lan. How can i configure ...

We need to apply IDS-sig-4.1-4-S162.rpm.pkg to our Ciscoworks SC. Is there an IDS-sig-4.1-4-S162.zip which included the NSDB and other required files?Thanks,Simone.

hi..first i would like thanks Cisco to give me this great Opportunity to ask the professional..my problem is that i cant telnet or run the PDM from outside the network, although through an IPSEC tunnel as Cisco Advise.. !! I can telnet and run the PD...

I'd like to know if there is an easy way to view events that caused the IDS to shun a host.I understand there is Event Viewer standalone, with VMS and IDM. However, with event viewer, it is difficult to view (search) a specific event that occurred in...

Hiwe are planning to deploy cisco IPS 4200 series on our network. We have a redundant network so what I need is an a device that would react to threats(via acl, shun, resets) while in passive mode ( using span or taps). couple of questions1- Is this ...

All of a sudden, I've started getting alerts on RPC WinNuke Sig#:3345 from a domain controller to workstations on the internal network. I am unable to find anything that has changed, nor can I find anything that would cause this event to be triggered...