Other Collaboration Subjects

We are trying to replace a BPX with a new IPT configuration. However, the PBX has a number of OPX lines that go to various smaller remote sites and drive a handful of phones. There is no data connectivity to these locations.I'm not sure if these OPX...

Hi, I currently have the fllowing situation:Cluster 1 – 322C, SP H Cluster 2 – 322C, SP H Cluster 3 – 335 Cluster 4 – 322C, SP H We are adding CER v1.2 and am wondering if the CCM versions must all be the same to support intercluster trunking?Thanks,...

We have PA integrated with Callmanager 4.1 it worked fine. Recent the wildcards configured in Call Manager don't work anymore. The interceptorports with the wildcards (48XX) don't intercept a pa user anymore. When we create a route point with the exa...

Hi,Can you please help me ? I am trying to setup an interconnextion betweenn an s0 interface of a pabx and a cisco routeur. However, I cannot established any communication and I am really stuck.Here is some debug :voipgw.gs.par#sh isdn stat Global IS...

There a few to choose from Cisco's recommendation. Does anyone have any recommendation which anti-virus products works best with Call Manager 4.1(3) and Unity 4.0.4Thanks,

When a caller from the PSTN calls an IP phone which is configured to forward the call to another PSTN number the caller gets a fast-busy. Can anyone explain why and is there a workaround to get the call routed to the PSTN.

I have an IP telephony network, with a CCM 4.1(2)sr1 - inside the LAN of course, and three remote sites, with a FXS card equipped router each. There existed a simple VoIP interconnection between sites before CCM deployement in this site.Now I'd like ...

hi allhow to change the up stream and down stream bandwidths.thanks in adv

I've recently upgraded to CallManager 4.1(2) and I've noticed that the Auto Numbering of phones when I plug them into the system is now always incrementing, even when the lower values are available...ie. 1920 comes up on a new phone when 1900 and 19...

Basically is it possible or anyway for both IP Phones (callmanager) and Legacy phones (PBX) be able to ring at the sametime simultaneously when somebody dials the main number, which goes through H323 gateway?Is there anything i need to configure on t...

Hey all,I want to setup a small VoIP solution in my house and I have the slightest idea where to start. I am thinking of Using Vonage as the provider. What sort of equipment would I need on my end to make it happen.I was looking at an 1801 router so ...

I have a 2821. Incoming PSTN calls come in to a 4 port FXO card.voice-port 0/0/0 output attenuation -1 no comfort-noise connection plar opx 51700 caller-id enabledial-peer voice 3220 pots preference 1 destination-pattern .T incoming called-number . p...

I am trying to understand how to form axl messages properly after looking at the schema. For instance I formed the following message using the schema and it didn't work. What is wrong the following message? Maybe by understanding the the problems of ...

What are some of the 3rd party paging solutions and the pros and cons of each.We need to setup paging, and are unable to decide on a solution.we are running CCM4.0.2a

Is there an IP service (or something else) that I could use to allow my customers with multiple lines on a 7960 to be able to ForwardAllCalls for individual lines to another extension?