Hi, I wish to know whether we can use IP phones to perform call pickup the PBX phones? The connectivity between the PBX and CCM is via a 3745 voice gateway with Q.SIG E1 link.regards,Steven Lee
I have 7 - 7960 phones with a shared line appearence. Even though there are no messages in the shared mailbox the envelope Icon will not go away, the MWI is off.
My Setup: CCM4.0.2a SR1, OS 2.6 sr6, CSA 4.0.3.728My Problem: The ipvmsapp.exe is experiencing high CPU utilization (99%). It seems to occur randomly. I am still investigating but just posting here to check if anyone else is experiencing the same pro...
I would greatly appreciate if could please provide some technical assistance to my questions below:Is it possible to make a VoIP call between two 837 ADSL Cisco routers over a 1Mbps ADSL broadband connection?If so, can I configure this VoIP connectio...
Hi, I've just upgraded from 334 to 402aSr1 and have noticed a change in call pickup. In 334, lets say ext 2000 calls 2001, ext 2002 then does a call pickup. 2002 would then see on the screen From 2000 and forwarded from 2001. In 402 the display on 20...
Does Cisco have a document that spells out the requirements/recommnedations as to what the maximum number of wired(7940,7960,7970 etc..) ip phones that should be configured on a single voice vlan? I found all kinds of docs for builiding a WLAN IP pho...
I want to allow PSTN callers to call IP Phones. I have E1 gateways terminating in Catalyst 6000 which are registered with CCM. I have 2 lines one is with VoIP and the other for PSTN. What I want is when anyone dials from outside or from line 2 which ...
Hi All,I'm having a problem with a VIC-2FXS that disconnects on answer. When dialing in, the line rings once and then you hear dialtone. Dialing out works OK. After dialing in, the line isn't released. Show voice call Summary look like:3/1/0 ...
We have a client with international dialing issue.They have a AT&T PRI ,4ESS switch , Call manager 4.1.2 SR1.I think AT&T doesn't look for 011 for international calling but they want to tag international calls.It was working fine when CM was on 3.3.4...
In version 4.1 everytime you browse to CM a popup appears saying the SSL certificate is not valid. Is there a way to remove this popup? Once you click yes to continue another authentication window popup requiring username and password. Is there a ...
hello.7940 and 7960 phones used on CME,before 1 week.of course,using voice vlan. (vlan 1 and vlan 2)today, i connect 7940 and 7960 phones on CM 4.0.WE only installed vlan 1.now, phones are very strange.i only see "protocol application invalid" on LCD...
Is there a way we can use one route patter for 1800,855,866, I only can think to use 18xx,but this will include all the 800 numbers. any good suggestion? Thanks
hello.7940 and 7960 phones used on CME,before 1 week.of course,using voice vlan. (vlan 1 and vlan 2)today, i connect 7940 and 7960 phones on CM 4.0.WE only installed vlan 1.now, phones are very strange.i only see "protocol application invalid" on LCD...
