Other Collaboration Subjects

Resolved! CCNP Collaboration Exam Conversions

I had a question about applying CCNP Voice exams towards the CCNP Collaboration:If I complete some exams before 10/30/2015, but I don't complete the rest of the exams until later on, do the CCNP Voice exams still apply towards the Collaboration certi...

Voip configuration

hello , I cant make configuration of ip telepone inter vlan routing with 3560 swith. I have router 2811, multilayer switch 3560, 2layer switch 2560 , ip telepone and pc.In packet tracer i have made topology like this and i didn't know how configure ...

Which MIB can read the number of used ISDN PRI channels ?

Hi All,the title says it all really, I have added a MIB already to my PRTG monitor but the number of channels that it gave me does not much up at any time at all with what I see on my 3925 router.Please help.ThanksFraser

HSRP and SRST

Has anyone used HSRP with SRST successfully? Have dual 3945 gateways for resiliency and would like all phones to register to single gateway in SRST mode, which would be the HSRP primary at the time of a failure.

Resolved! outgoing calling translation does not work on FXO lines

Hi,Customer has a CME with 6 FXO lines going into it. 3 lines are for incoming calls and 3 lines are for outgoing calls. They want the people calling from the outgoing lines to display the DID of one of the incoming lines number for dial back. Howe...

CWMS on premise - "A server glitch occured" - MOJOCO

Hello people, We encoutered a database crash on one of our CWMS cluster. During this crash, we were not able to connect to the web admin page, and get the attached error message.I'm wondering, why the MOJOCO logo appears at the upper right corner. Di...

Resolved! Tandberg 880 MXP key

Hello, I recently purchased a used Tandberg 880 MXP, it was working fine however I made a config change that cause it to reboot over and over so thinking I would fix the issue I did a factory reset on the device. I was unaware I needed to copy down t...

Resolved! Collab Edge MRA-B2B-Jabber Guest Question

Assuming a client wants to deploy MRA and Jabber Guest Expressway C/E Pairs where does/should B2B calling be handled, on the MRA pair, or Jabber Guest pair?? The current Collaboration Preferred Architecture guide states MRA (Jabber and Endpoint Regis...

Resolved! Can I use two touch 10 with SX/MX endpoints?

Hi All, In Cisco's project work place webpage, I see the design for large room with MX800 and two touch 10 associated. Is that supported for all SX and MX series? How many touch 10 we can connect? Thanks! Lou

Show and Share Connection to video server failed

I have an SNS server running version 5.2.3. Everything time I try to play a video I get an error stating Connection to video server failed. I am storing videos locally on the SNS server. I can't figure out why I am getting the error.Thanks,Jim ...

Resolved! voicemail

Here is the strange situation for me.I have a call manager version 10.5 , Today in the morning one of colleagues said that on his cisco phone 7911 there is a red light and text you have voicemail.But In my system we do not use any voicemail ...

Resolved! Unity Connection uptime in PefrMon logs

Hello Guys,Is there possiblity to find out uptime of a server in Perfmon logs ? Unity Connection 7.1.5 crashed and I want to know what was the server uptime. Is it possible to trace it back ? Thanks for feeback, Matej

Cisco VCS MRA - There are no Unified Communications traversal zones configured.

There are no Unified Communications traversal zones configured.On Jabber client, I am getting "cannot communicate with the server" I have attached the screenshot anyone please help me. thank you.

New to Expressway C and E and need help with certificates.

So, I'm new to expressway C and E and need to get the certificates going but I'm not really finding something to satisfy me.We have a pretty basic expressway setup with (right now) just IMP and CUCM that will be served through the expressway. Expres...

Certificate Required for MRA

Can anyone tell me how many certificates in total i need to deploy Mobile and Remote Access feature for jabber. Appreciated!

Other Collaboration Subjects

Forum Posts

Resolved! CCNP Collaboration Exam Conversions

Voip configuration

Which MIB can read the number of used ISDN PRI channels ?

HSRP and SRST

Resolved! outgoing calling translation does not work on FXO lines

CWMS on premise - "A server glitch occured" - MOJOCO

Resolved! Tandberg 880 MXP key

Resolved! Collab Edge MRA-B2B-Jabber Guest Question

Resolved! Can I use two touch 10 with SX/MX endpoints?

Show and Share Connection to video server failed

Resolved! voicemail

Resolved! Unity Connection uptime in PefrMon logs

Cisco VCS MRA - There are no Unified Communications traversal zones configured.

New to Expressway C and E and need help with certificates.

Certificate Required for MRA

Congratulations to the Event Top Contributors Class of 2024!

Cisco + Splunk: It's a new day for your data.

A new chapter of the Spotlight Award begins!

Join us in Celebrating the New Year and the Nov.-Jan. Winners!

Announcing Resources That Guide You to Success

Nexus 9300 vxlan

Cisco Emergency Responder Phone Queries Not Loading for Any Fixes?

Cisco Champion Radio Podcast: Crystal Clear Audio with Webex AI Codec

Cisco Champion Radio Podcast: Cisco's AI Cinematic Experience

E&M card in VG450 trying to use port for overhead paging?

CUCM with Webex on Premise

Data Export fails because of SFTP Server

Cisco Device Patching

TLS handshake failure CUBE to ITSP

CUC Directory handler and cucm