Other Collaboration Subjects

Hi,I would like to configure the Cisco 2600 for using H323 voice. Actually, the router have 12.1(5)T9 version. I tried to use the H323 commands to support E1 connection but its aren't recognize.I think this version do not support H323 using E1.Could ...

Hello I uses the CCM 3.3(2) spc and has a Conference Bridge software in use. My problem is that I only 10 calls use in a Meet ME. Can I increase the number?Regards,Marco Meier

Hi , i am running voice using 1751 routers with FXS cards in voip mode.I want to voice to prioritise over data, cos i observe voice breaking when using data at the same time. I am unable to set "ip precedence' in dial-peer is there any ...

I configured an VG 200 as the H.323 GW for CCM 3.2.2(c) using a FOX port. All configurations on GW and CCM are very essential. But the 7960 phones will keep ringing 3 times after the PSTN caller hung up, no problem with internal calls.

CM 3.3.3, IP-Phone 79XX, User/Net Locale RussianHow can I change char sequence typing when I make search in Corporate Directory? I'd like to English char will be first, and the local char will be last!

Hi,just wondering if there is an utility that you can schedule rebooting of the CCM similar to Unity's Schedule Unity Restart tool?? thanks in advance.

Hi, a customer of mine upgraded his 7960's to 5.1, and after that the 7960 keeps rebooting over and over again. Since downgrading seem to be impossible, is there any logical explanation for this behaviour? And do any of you know a solution?BRCalle

Can I achieve this by using hunt group or something else?What we want is if someone calls a number, 10 phones should ring together and any one of them can answer the call.If second call comes in, the other 9 phones should ring. Then 8,7 so on.ThanksS...

I have just installed a Unity 4.0 with Platform Specific disks. I want to enable Network Fault Tolerance on the two NIC cards. The install guide suggests to refer to documentation provided by NIC manufacturer. Do I have to update the driver to get...

CallManager 3.2(3), Unity 4.0(1), TSP 7.0(1)CallManger Event Viewer every few seconds:Event Type: ErrorEvent Source: Cisco CallManagerEvent Category: NoneEvent ID: 3Date: 8/2/2003Time: 6:18:39 PMUser: N/AComputer: HOU-W-CCM1Description:Error: Devi...

In our UM 4.0.2/Exchange 2000 installation, we get email NDNs in the voice mail stack. I've suppressed return receipts using the advanced settings tool, but non-delivery notices for email appear as voice messages & it freaks out some users who don't...

How do I set my CM 3.3 to recognize the call handler extensions I programmed in Cisco Unity? For example if i dial extension 555 i want to to be the cisco unity greeting.

Sh ccm-manager shows registeredIn CM the vg200 with NM-2v says registered to CMThe NM-2v has 4fxs ports 2 cards with 2 FXS ports on on each card.sh voice call summary shows port 1/1/1 is constantly connected.When this shouldnt be the case.When number...

A DN has been deleted in CCM, but the number is still called by someones from outside and callers always hear busy tone. If I expect all the calls to this DID numbers are forward to reception or another sepecify DN. What's the best solution for this ...

A customer set up outlook to have the Voice Mail go to a folder call Voice Mail. Of course the MWI does not light. Once I had her move the voice mail back to the inbox everthing works fine. I just wondered if there is a way setup Unity for this on...