Hi all,how can I load 7941 phone on CME, what parameter should I enter in config,I found somewhere:load 7960-7940 P00307020200but this file I am loading for 7912 IP phones, so what is correct?regardsSlawek
hi all,have the problems as described in Tac Case Collection "K13474527" "Calls drop and the user receives the CM Down Features Disabled error message when making calls with a Cisco IP phone".This is independent from srst or wan failures, because the...
I have configured my router with CME 3.3 and now I'm trying to configure an autoattendant, I have tried a lot of things but it doesn't work, this is my config:!version 12.4service configservice timestamps debug datetime msecservice timestamps log dat...
In Unity I have a call handler that is the main greeting for an office. If the call presses one, it transfers them to a new call handler that promts them to enterthe extension of the person they are trying to reach. If the extension is valid, it tr...
2811 on 12.4(3c), MGCP w/ CCM 4.0(2a)SR2b. My PRI dropped for 2 minutes yesterday and when it came back up, incoming calls resulted in reorder. Q931 debugs showed the call presenting to the router, but the router was dropping the call immediately, ...
I just brought up a site that should use only G729 between other sites and internally. Reviewing CDR data I see a occasional call using G711. Most of these calls go to Unity but I can see no reason why this would be. There are also calls to Unity th...
Working on a Nortel integration with Unity using a intel Dialogic D/120JCT. As soon as I plugin the analog line they go off hook. If I connect a phone I can make a call. I tried changing SW1 settings.. no luck Do I have a bad card ? Its the only c...
My company recently purchased two MCS 7835-I servers, 1 Unity bundle, and 1 CallManager bundle. When I tried installing the IP Telephony OS 2000.4.3a it fails with error message:"installation program has determined that this server is not supported ...
Users in a site experience issues with internal calls routed via call manager. But PSTN calls are working fine. There are no issues with the network. It would be nice if someone describe me the troubleshooting steps to be taken?
i configured a meet me number by the book and it doesnt seem to do anything. i press meetme on the phone enter the number - then on my cell i'll enter the meet me number and it just rings. according to the book it should work by pressing the meet me ...
i have internal 2 dial plan one range is 000 to 199 and secend range is 700 899. i configured the meet me conference. the range is like 55X. some body help me how this ll work how i ve to intiate the meet me or what extra parameters required
