Other Collaboration Subjects

as anyone managed this yet if so please share any tips.TIA, Jeff

Hi,Does the CCME able to support FAC features or any forms of IDD authorisations?Best Regards,Jeremy

Hi all expert,Can cisco call manager express generate call accounting report?How can I do this?Thank you.

Hi Is it really true that CCM doesn't support any other noncisco voip gateways,ATAs, softphones? how can this happen?

Did u know if i can configure an intercluster trunk between a 3.0(8) callmanager and a 4.1(3) callmanager???That version is really old but l need these information ... thank for your help

Hello, I have CME running with the IP phone paging feature setup in one paging group and I also have a FXS port interfaced into a Bogen TAMB for overhead paging. Is there any way that I can have both these paging functions in the same group. So it's ...

Does anyone know if TAPS is supported with CCM 4.1.3SR2 and CRS 4.0.2? I just installed the taps component on the CRS server and I can't find the TAPS.AEF script anywhere.

I want to created an ip phone service, that basically does some database lookups and calls some number. can some one point me in the right direction of where to start and are there any companies that design these services already?Thanks

Hi, We are having 7912 Ip Phones connected to WS-X6148A-GE-45AF modules in 6500 switch. If we leave the Port duplex and speed to auto or force it to 100 full in switch side we are getting lot of runts and undersize errors.Due to this voice quality of...

Hello all,I'm trying to add an MGCP gateway: a 2811 w/ VIC2-2FXO. I've brought up several of these gateways, all with the same configuration, with no issues. However this particular gateway never registers.The endpoints always show up as "Not Found...

Hi I have install CCM 4.1.3 sr3and CRS 4.03When I install taps on the crs server I do not get the usual script installAnybody help

I was trying to upgrade a phone image to solve a problem with cut outs on the phone. Well...I got some bad instructions from a vendor and I wound up uploading a SIP image to my 7912 phone and I can't seem to get it to use the version on my CallManag...

Hello,Does anyone know how to get directly from database report with number of phones configured on CCM and phones registered to CCM? I need this for network with a few CCM clusters.

Is there a way to add the extension mobility to a large number of phones at once? If so, would this allow anyone with a profile already attached to their ID to log on to these EM enabled phones? I realize that users will not be able to log in witho...

Is it possible to have call routing based on the incoming caller ID instead of the dialed number in the following senecarios:(1) Calls from PSTN to CallManager 3.3(2) Calls from PSTN to CME system 3.1Thanks,JJ