Other Network Architecture Subjects

Howdy,I'd like to use some mode conditioning cables so that I can run my long multimode runs at 1G. For GBIC's, I think I'm okay, since that cable, CAB-GELX-625, is duplex (contains strands for both receive and transmit). However, for SFP's I think...

I have a 7606 with redundant SUP II's running native IOS. I want to disable core dumps. Can someone please help me with the command?thanks,Bill

I am getting following error:Event Message: Port_Performance_dot3_Ethernet PORT-xxxxx/1.32 [Fa0/32] [yyyy Z3-MGMT] is HighBroadcastRate. Indicates that the input packet broadcast percentage exceeds BroadcastThreshold.and after 14 minutes of time, go...

Hi, i've configured route maps onto a 3550 and they do not seem to be working at all. I am running the Enhanced image, Ver c3550-i5q3l2-mz.121-22.EA4.bin.I have also configured the SDM for: - sdm prefer routing extended-matchI am getting no debug out...

Hi There,This is really wierd, it happened with me twice within 1 month. For no reason, I found out that a switch port is SHUTDOWN, I know that some STP instability might cause a shutdown, but I do know that it will show as"ERR-DISABLE", but my case ...

Folks,we are going to deploy a VPN network using 6500 and the HW Encryption Module and we wonder if there are Firmware dependencies between the different modules.I'm looking for some sort of a table and I didn't find anything on CCO.Have one of you g...

INTEL NIC teaming with Static Link Aggregation mode (PAgP protocol) for cisco2940 switchI'm trying to configure INTEL NIC teaming with Static Link Aggregation mode (PAgP protocol) for 2 network ports, but network doesn't become active after the conf...

I'm using 3560's and 3750 switches at the access layer (L2), and 6509/sup720s for dist & core (L3). I have PIM sparse-dense-mode configed on all L3 ports in the dist/core 6509 routers, with two of those routers config' as RP's. Do I leave everythin...

could I interconnect these two interfaces ? are theycompatible ?PA-POS-2OC3 PA-POS-OC3MMthank youf.m.

Hi What are the advantage or disadvantage between these modules?

Hi,Is it possible to configure GLBP on a Cisco Catlyst 3550 L3 switch??We have two 3550's at the core of a small network connecting to 6 access switches to which the users workstations are connected.The 3550's are set up with vlans and route the traf...

HelloI have doubled my companies bandwidth by using a NIC teaming solution. I have used the HPNC7782 to configure the server, and the NICS with the same IP addresse and MAC however I repeatedly get a Error messages from the switch. MLS-4-MOVEOVERF...