Other Network Architecture Subjects

Hi everybody. I need a fast response on this one if you dont mind :) As my previous message.I installed LMS on a server, RWAN on another server, ITEM on another server and QPM module on another server. In total I have 4 servers. The main problem is i...

Hi,I am having some issues with BOOTP/DHCP forward on a Cisco 1751 router (IOS (tm) C1700 Software (C1700-K8SY7-M), Version 12.2(4)T3, RELEASE SOFTWARE (fc3)).I have set-up an ip helper-address on the LAN interface as there is no DHCP server at this...

Hello,A customer of us, has a virtual server farm based on VMware ESX ( with internal a virtual switch). Our network has multiple vlans per hosting switch ( 6500 CatOS, MSFC, IOS). We have 3 Catalyst switches for hosting, and each vlan has his own di...

I want a router with 4 serial port(v.35) and in future i want it to be upgraded to 8 ports.it must have a 1 BRI port also. please tell which router to choose.

hi, I was wondering if it possible to add an 1enet card to the cisco 2611 to make an DMZ. We're currently running DSL and the 0/0 is use for the DSL and 0/1 is for the LAN. What do I have to do? Thanks

Hello, what we trying to do is have an extra Ethernet interface for our DMZ. I added an 1enet to our cisco 2611 router but the router didn't seem to see it. can someone help me what is going on? Thanks

Yestaday when i cold reset my 2948-l3,the below message was output:device does not contain a valid magic numberboot: cannot open "bootflash:"boot: cannot determine first file name on device "bootflash:"......I tried to reset again,but it didn't work ...

Hi all,I have some connections problems with AS3745 installed in Turkey.The line quality seems to be very bad and I cannot find the good mica modem configuration to solve this problem.Perharps someone has the solution to configure correctly the mica ...

Dear All,I have 2 routers 2650XM and they are working fine except when i try to reload them while i'm telnetting them both boot in rommon mode so i have to reset them to boot normally..What do you think?!!Tamer

My apologies if this is not the right place for this question as I am new to this site. I've just got CICSO 837 with the security Bundle PLUS feature set, but I have a few questions:1. Should I have got a documentation CD with the product as there w...

Yestaday when i cold reset my 2948-l3,the below message was output: device does not contain a valid magic number boot: cannot open "bootflash:" boot: cannot determine first file name on device "bootflash:" ...... I tried to reset again,but it didn't ...

In viewing the mac-address table on a 3550 I found 48 static mac address entries like the ones below:Vlan Mac Address Type Ports---- ----------- ---- ----- All 000c.316c.6480 STATIC CPU All 000c.316c.6481 ...

We have a 4506 switch with Supervisor Engine 2+.The IOS we use is 12.2(20)EW (cat4000-i9s-mz.122-20.EW.). That is S4KL3-12220EW - Cisco IOS software for the Catalyst 4500 series switch, basic Layer 3 and voice software image (RIPv1, RIPv2, Static Rou...

I set the ip address on the NAM and started the http server. When I type the ip add. in my web browser nothing happens, it can not connect.