Other Network Architecture Subjects

I am looking at a Catalyst 6509 switch with the route switch module, running IOS 12.1(2)E. However, I do not have an understanding of the IOS upgrade path in this instance. Specifically, does the upgrade have to follow the 12.1(2) path (for example...

Hi Folks:I am looking for the correct Cisco product(s) to create a network accross a two wire loop (Pots). Each two wire loop would not exceed about 2 miles.Also, any ideas on expected throughput would help. ie. MBPS.I would like to connect multiple ...

I have been out of the WAN world for about a year now and my memory is slipping so I am hoping for some help. I need to extend 4 T1s from a SmartJack (with the RJ48/RJ45 on the back) to a 2691 router. Can I accomplish this with a standard straight ...

on a cisco 1603R runnin 12.2.26when i debug the below access list traffic not matching the permit rule gives debug output. the same debug command on any IOS 12.1 does not do this am i doing anythig wrong. my problem is that doing this debug on 12.2 d...

I would like to be able to track resource usage by process for each user logged in to the application using mpstat or something. I have the most current versions of LMS and RWAN running on Solaris 2.8...

HiDoes anybody how many users I can support with one appliance of VPS?

Say you have a network of say 800 devices and you need to make something like a password change on all boxes , what is the max number of devices that should put into a job . Is there a limit? Had previously heard that you should put no more t...

My question is whether the slot1 and slot2 of 7609 can support OSM module or other line card when 7609 is configured with two sup720 in slot5 and slot6.because the document said that slot1 and slot2 are reserved for super engine 2. Pls help me!!!Th...

Does this model of router has limitation on the number of serial cards and ge cards, as i have one serial card with 12 modules and 2 ge cards. i am able to config only 1 ge card. kindly suggest

ok I am designing a network for a school project and need to verify one thing. Here is the scenario:I have a client connected to Router1, Router1 in it's turn is connected through the serial interface to Router2. all devices have ip and subnetmask as...

After replacing a Sup1a-2ge with a Sup720, I'm receiving an error that the 6608 T1 card is unsupported and will not power up.Is the 6608 T1 card with the Sup720?The 720 is running 12.2.18 IOS.

I have a request and I will simplyfy it below :)SCENARIO :-I have a router and two LANs. Host-a on LANa sends too much traffic to a server-b on LANb. The two LANs have other client/server apps which are suffering because of of the host-a/server-b t...

Hi, I am planning to upgrade the current core from hybrid SUP1+MSFC+PFC to SUP2+MSFC2+PFC2. I need to enable the IP PIM BIDIR for multicast and cutting down the multicast routing table. Does anybody know which MSFC2 IOS should I go for? It will be i...

I have on my 2948 (with CatOS) trunk on port 1/1, allowed vlans in thistrunk are 1,20,30with command show trunk 1/1 i see that native vlan for this trunk is VLAN 20, I need native vlan for this trunk VLAN1How to set native vlan in trunk, command set ...