I am attempting to configure a 1721 router (12.2.13t3) with an ADSL connection and an ISDN backup. Individually both parts of the config work fine, but when I put them together I have been unable to get the backup working. The ATM will go down, and...
When config. a router.1 - Serial Interface connected to ISP fractional T-11 - Ethernet Interface connects to hardware firewallISP assigns Serial Interface IP -1.2.3.4/29ISP gives me a block of public IP Address 1.2.4.193 - 1.2.4.198Do I assign the ...
I configed multigroup HSRP with GSR and ESR,vlan1 and vlan2,2 group,GSR is active router of the two groups. I find that,packets lost regularly when I ping from host of vlan1 or vlan 2 to the virtual ip of the two standby groups,but any other ping ope...
I have a cluster of 4 Catalyst 3550s and 1 3508G. I haven't had any decent networking management software until just recently so I never needed to enable SNMP on them. My base question is - "Does each switch need a unique SNMP community name? Does it...
hello, I have a 2610xm with an 8 port isdn module. Right now we use MS for RAS and would like to get rid of it and use this router. I have ACS in the network and would like to know how to configure the 2610XM to allow people to RAS in using it instea...
I have just installed LMS 2.1 which includes RME 3.4. Performance generally is pretty good with the exception of RME. Its performance is atrocious!! It has taken me 10 minutes to create an approver list of 2 people!! The web interface just runs like ...
Hello,Is there some problem with snmp on c7206VXR with Gbit Ethernet interfaces ? When collecting counters on Ge0/1 it's all ok,the counter is incresing in time,but on Ge0/1.1 counters first increse than decrese with no pattern in it ?Any clue ? IOS ...
Hi All,We are in process to setup an NMS. However as an interim measure we would like to have a Configuration backup script which can automatically backup the configuration of all routers. Also, we need some script which can periodically test the end...
Hi all,If one has two distinct connections to two ISPs, the next step might be to propose to them that they run BGP with oneself, and have the two of them advertise my (single) address block to the world. In the UK (RIPE jurisdiction), what does it r...
hello,imagine a fully loaded catalyst 4506 scenario (data only, 4x 48-port 10/100 RJ-45 and 1x 24 port 10/100/1000 baseT, supervisor engine IV) with two 1000W AC power supplys.does one of these ps deliver enough power to keep the system running in th...
Hi,I am testing the IPv6 PPPoE with a windows client and a Cisco 3745 router. I am able to negotiate the IPv6 addresses - both link-local and a global prefix assigned from a pool. I am trying to ping another windows client connected directly to the f...
I have a Catalyst 4006,Version NmpSW: 5.5(20), that reboots about every two weeks and I'm not sure why. After the reboot my Syslog shows that Mod's 3, 4, and 5 are online, why not 1 and 2 as well? All the cards show that their ok. That switch did ...
