I have 2 servers balanced..I have a cookie-insert set for 15 minutes...when I access the virtual server and press refresh, it bounces between the two real servers after 10-20 seconds...Should I use the cookie-passive?
I have a question on why there are discrepencies between my LS1010 ATM interface and my 7206 router ATM interface counters? The output of my router is 3Mbps and the input of my LS1010 is 1Mbps? This just an example but I see the same thing throughout...
Hi. We currently had four main building with a Cisco 3550 on the ground floor of each linked in a ring by fibre at 1gb.Links to floors to each 3500 at 100MBPSWe have maybe only or or two links to a floor - so often switches are diasy chained at the f...
Does anyone have experience of developing test environments for simulating a Worm-based Denial of Service scenario on a routing infrastructure? We are currently looking to simulate an environment where a router is experiencing CPU overload and memory...
Save yourself from headaches by properly grounding your racks!!I was constantly replacing switches due to lightning and general power problems related to our buildings.Some of them were just fried while others just started acting strange.I had our ma...
I am setting up a remote site to access the network at our main office using two PIX501's.I have established a tunnel between the two sites which allows me to ping from one network to the other and back again. However I cannot log on to the network ...
My question is regarding broadcasts on a VLAN interface. I have a high proportion of broadcasts on my MSFC2 VLAN interface, see below.My theory is because MLS is enabled, unicasts on a whole are being L3 switched by the switching engine, not hitting...
Hi,I'm having failures on my Medium buffers. I would tune the buffers, but when you try to change the medium buffers you can't, there's no option.You can change small & middle, etc.. but not Medium!Dave
could someone reccomend what IOS ver to run on a 1760 router with a WIC1-SHDSLv2 card installed as i am getting different suggestions from different providersmany thanksDave
OSPF can load balance with two lines, one router at source and one router at destination.But can OSPF load balance with two lines, one router at source and two routers at destination. The two lines are connected to Router-A at source and Router-B and...
Using CBWFQ to help certain flows receive adequate bandwidth during times of congestion. One thing I haven't been able to get a grip on is limiting certain flows to a maximum bandwidth - period. I could accomplish this somewhat by strict (priority)...
Looking for documentation to setup Cat6500 switches running Version 12.1(19)E1 as a NTP Servers. I'm thinking of seting up local ip gateways on the L3 Switch to be the ntp server for each subnet. Your input is appreciated.Background: I'm installin...
I have voice ports configured on a 3550-pwr with IOS 12.1.14 and and 7940 phones.ports are configured as:interface FastEthernet0/1 switchport trunk encapsulation dot1q switchport trunk native vlan 2 switchport mode trunk switchport voice vlan 5 spann...
Hi all, My company is gettting a bundle of T1s from the same ISP to create a big pipe of 6mb since we can't get a T3 here. The thing is this IPS doesn't support Multilink PPP and CEF... I was told that I need to use Source/Destination routing to cr...
