Other Network Architecture Subjects

I have a private vlan setup on two cat4006 switches.Vlan 902 is the primary(promiscuous vlan) and vlan 904 is the secondary(isolated) vlan. Is it possible to set up a additional community vlan (e.g 905) and map it to the existing primary vlan 902 tha...

For some reason, I do not have running configs for many of my devices in the archive/config tree, and therefore they aren't in the shadow directory tree either. I just took this over so I don't know the history.All devices are properly managed and "U...

How can I request the SDK (workable code) to develop an interface and other functionalities on top of CiscoWorks?I am the third party developer.

I am looking at a 6500 configuration (IOS 12.2(14)), and I am trying to determine exactly what is going on and more importantly, if the switchport configurations for the interfaces are SECURED properly. The following lines are configured on the inte...

Thanks.

Hi ;A very novice question We are currently running 12.0(6) and have moved to 12.2(23) on a cisco 3600 router ;can anyone point the biggest advantage we have got by moving to this version . I am trying to find this on Cisco Site but not much helpfull...

Does anyone know how I can audit the address, MAC or IP, of a device attached to a particular switchport?

Hi there,I am trying to install a module (WS-X6516-GE-TX) into the Cat6506 (Cat OS ver. 6.1(3)), i got an orange LED on the said module and i saw "an invalid index feature on module 6". Any idea?Thanks!

Can the ports be configured to Auto negotiate the speed for just the 10/100M but not the 1000M ? In other words I'd like to control the Gig connections.

There was an error message in my catalyst 3500XL,The details of the message as shown as following:C3500XL Boot Loader (C3500-HBOOT-M) Version 12.0(5)XU, RELEASE SOFTWARE (fc1)Compiled Mon 03-Apr-00 17:47 by swati starting...Base ethernet MAC Address:...

Can any one help me to configure a 2950 switch for Port security, I am trying this commandsSwitch(config-if)#sw port-security max 1Switch(config-if)#voailation mode restricted

I am running cat6500 with MSFC, would like to have acess control to one particular vlan. Can someone provide some configuration example on vlan acl?Thanks