Other Network Architecture Subjects

Hi all,the catalyst 6509 with CatOS and IOS has the auto-sense mdi-x feature??I didn't find this feature on web site, but if i connect the 6509 to another layer 2 switch ( 2950 or 1912) with a Straight-through cable or a cross cable the link goes up,...

We have just purchased a 2610 router with a 16 port asynchronous module. This is going to be used to provide secure remote console access to our switches by connecting to the 2610 router and then opening a console connection to switches.Is there a d...

Hi all;I have two routers at different locations that are basically "open" as they sit in front of firewalls and pass all data.My firewalls are doing all the protection as they are setup as a VPN between the two sites.Both are 2600 series with one ve...

Is this correct - Say I have 20 VLANS defined on my network and have multicast traffic going over any given trunk....will I have 20 instances of that traffic (one for each VLAN) going over that one trunk?Would VTP pruning handle this? How about defi...

We are using Cisco 2610XM and NM-16A (16 Port Aysnchronous Module) and 2 sets of 8 lead ocatl cables to make a terminal server. This is going to be used for reverse telnet purpose.The configuration file is as follows:TerminalSrvr#show runBuilding co...

Hello alli am trying to figure out how to apply the command ssg pass-through only for a specific subnet of the incoming traffic from a Serial interface (downlink).Any examples?

We have two locations connected through a 2Mpbs IPLC Line and we are using Cisco 3640 routers on both the ends. When we are doing a ftp download/upload the cpu utilization on the router shoot to 100%. Other Data, Voice and Video Traffic does not util...

Hello,I've got a 7206VXR (with a NPE-300). I am having problems getting the SA-VAM module to work in the router. When inserted, I get the following error:Mar 8 13:05:30.731: %OIR-6-INSCARD: Card inserted in slot 1, interfaces administratively shut do...

I am using VWIC-2MFT-g.703 on Cisco 2611, I have configured frmaed E1 on it with timeslots 1-31, framing is no-crc and clock source is line, but I keep on receiving Line Code Violations and Path code Violations, when I used interface convertors from ...

Hi,Anyone know the default value for a LMS session timeout befroe you get the 'Your login session has been terminated' message ?Also if you can specify another value.Have had a look round the product and tried searching the on-line documentation to n...

I just installed an "old" version of CWLMS (2.0) on a Win2k server with SP4. I get the java errors, but more seriously, when I try to initialise CM 3.1 the pop-up window stating the ANI Server Starting, remains forever and the process does not initia...

We currently have two locations(Site A and Site B), connected via fibre, both having BGP sessions with upstreams (Site A having two upstreams, Site B having one)We have an aggregate advertisement of our entire /20 at Site A, and a more specific adver...

I have a questions that some documentations on the enternet misled me in its answer. Is there a difference between the band width and the bit rate? Some documentations say that the band width has two meaning one for the frequences and the other for...

I have 3 lease line which from different ISP for connect to Internet, I want to bind it together. I have a 2611XM, I wish these lease line can share its bandwidth. how can I do?

Hi all, This command appears to be missing from the new Cisco SOHO 97-K9 ADSL routers: route-map nonat permit 10 The SOHO 97-K9 apparently supercedes the SOHO77H on which this command was previously available.This command is apparently required to ...