Hey.. sorry for the probably ridiculous newbie question... but I just went through initial config on a 2950 and chose fa0/1 instead of VLAN1 for the Management LAN. How can I change it back to VLAN1 without having to reload? Anyone know the comma...
Does anyone know what is the command to send a dummy snmp trap from a cisco 3600 router to a NMS.I know Cat 6500 can do it, so I guess there is a way to do it on the Cisco router.
I am confused about VTP, and I'm sure someone here can clear up my confusion.Currently, most of our closet switches are set as VTP clients getting VLAN updates from our core switches (6500's). When I do a "show vlan" on the closet switch it will sho...
Hi,I'm trying to set up an 802.1q trunk between the buit-in 10meg ehternet port on a 2611 router and a cat 3524 switch. I am running release 12.2(11)T10 on the router. The subinterfaces will come up but I can not ping any devices on the vlans on the ...
Hi. I finally got bgp setup nicely on 3 routers on our network, but now I am noticing drops in traffic according to my snmp gauges and graphs.Here is a picture of one of the routers:http://poor.j3w.com/~tzulo/yipes-graph.jpgThe network topology is qu...
Hello, I have three vlans on a 3550-24-EMI switch. When I add the fourth vlan. It appears good. I do a show ip route and it displays only three routes.
Okay, so I need to be able to have a device plugged into my 4506 that will need to be referenced from two seperate IP addresses. I was led to believe that I could simply sub-interface this port and be done with it. However, the basic feature set does...
No interfaces found after auto discover in CWW 6.1Cards not found = WS-X6724-SFP, WS-X6748-GE-TX, WS-SUP720. Could this be an issue with the version of Whats up Gold (v7.04 rel 2002.08.23) being too old ?
I have worked on IPM to measure the response , latency etc for Cisco routers.I have a site to site VPN connecter ( Cisco VPN concentrator 3000 series) in my network.I want to monitor the end to end response for these sites.SO I want to know whether t...
Hello,we are experiencing some problems deploying a wireless LAN with Cisco 2500XL switches and Intermec APs and terminals. The users have cpmplained about experiencing some problems of connectivity in determined cells. I have seen this message in on...
Hi all,the catalyst 6509 with CatOS and IOS has the auto-sense mdi-x feature??I didn't find this feature on web site, but if i connect the 6509 to another layer 2 switch ( 2950 or 1912) with a Straight-through cable or a cross cable the link goes up,...
We have just purchased a 2610 router with a 16 port asynchronous module. This is going to be used to provide secure remote console access to our switches by connecting to the 2610 router and then opening a console connection to switches.Is there a d...
Hi all;I have two routers at different locations that are basically "open" as they sit in front of firewalls and pass all data.My firewalls are doing all the protection as they are setup as a VPN between the two sites.Both are 2600 series with one ve...
