Other Network Architecture Subjects

hi, please help me.the backup line between our company and branch office doesn't work. the following is debug result:11w1d: Channel ID i = 0x8911w1d: ISDN BR0/0: received HOST_PROCEEDING call_id 0x846211w1d: ISDN BR0/0: RX <- DISCONNECT pd =...

I want to configure teaming on the two 6513 switches and HP(Compaq) server..- HP(Compaq) server=W2K, set to fault tolerant with fail on fault.- 6513=native IOS, 12.2(17a)SX1interface Port-channel100 no ip address switchport switchport access vlan 10!...

I've a host connected to int fa 0/24, this is a web server.This port is the span source.The SPAN destination is int fa0/9, where a IDS is connected.Sometimes when the combined traffic rx/tx to the SPAN destination, rise above 70Mbit the source SPAN p...

Hi, I am new to switch and i was going through the article about the switches and in the article it says to allow traffic to pass through a particular port, then that port needs to be in the trunk mode. We bought a new 3750 Cisco Switch and the Switc...

Hi..I have installed 1 central 3550 and 2 more connected by fiber over giga ports.Al three switches are in the same Lan 192.168.1.0.I need to configure in one of this another network eg.192.168.2.0.The applications server has the ip 192.168.1.1, and ...

We are planning to lose connectivity through the one PVC after we reconfigure the local site connection with a point-to-point. We want to leave the hub router configured as a multipoint connection. Will this work? We plan to do this using these com...

I have got a question on the capability of the Gigabit module currently installed on slot 2 of my 4006 Switch. The Gigabit module model is WS-X4448-GB-RJ45. I have created etherchannel on port 2/33 to 2/44 and its working fine with a pair for one cha...

Hi,I have receive a range of OID as followings..not very sure where can i download those mibs and also what traps they are.can any1 help.

Hi,I am facing problem with multicasting , where I have 7206 router as RP (central location) . In remote location it is 3640 Router. I have 2 links from remote location to central router.We have PIM ver-1 enabled, with sparse-dense-mode.The IOS ver ...

Does the T1/FT1 card in 2600/3600 support multiple T1 bandwidth on a single port?We have high capacity microwave connection to a new remote site. We wonder we could bundle the multiple T1s instead of use a multi-port module. Can't find any hint in th...

What are the major differences between 65XX and 76XX in terms of technical specification? Almost all their major line cards such as FE cards, FlexWan etc and even Sup engines are interchangable. Their backplanes and switching performance are also ver...

I'm planning to put in a Cisco1721 with 2 ISDN card to support for 15 incoming ISDN call from remote site.Can it be done?each of my remote site has only a few users.

Cisco documentations says you can only connect the 500 series LRE CPEs to a Catalyst 2900 LRE switch.Is there any way we can connect two 575 LREs together to provide extended LAN connection, saving some money on having to replace our current switch w...

Hey all, I have a rather basic question. Am setting up a lab for messing with, and wanted help on configuring a 2521 as a small 4 port frame switch.I followed instructions in Cisco TCP/IP Routing Profesional Reference (man, that book has been on my d...