Other Network Architecture Subjects

Hello,is RME integral part of VMS? what features add RM to VMS?Thank you very much,Graziano

I have a number of 4006 platforms with varying degrees of port density. Most are running CPU utilization at around 55-65%. The largest user is Admin processes at around 15%. Is this a normal occurance? From time to time some of the ports (not all)...

My company has a 6513 as the core switch (which is configured as our DHCP server) and about twenty 3550s trunked from the core to make up our LAN. I have configured dhcp pools on the core as well as Vlans on the core. I have configured the interfa...

I have some 3524's that are running at 45% utilization. Is that hight for a 3524? I know in the router world, that would be high.Seth

Hi AllI am trying to configure my PC as an NTP client, however, I am unsure as to how to do this - the information which I have found so far seems to relate mainly to synchronizing with another server (Windows NT/2000) rather than a routerI have trie...

Hi,I currently have three routers, we'll call them routers A, B, and C, where I'm routing EBGP to external providers, and where I have IBGP on each with belonging to the same peer group. Each of these three routers are c7500s.Question: I'm bring up E...

I have Campus Manager 3.2 installed and need to upgrade to 3.3 so I can get the User Tracking Utility to work.Where can I get CM3.3 software to update my existing Campus Manager?

Hi all,I am having problems with my 1721 going in to a boot-loop after I applied new software. I have posted the results of the boot below and and wondering what I need to do to make this thing work again!********Cisco Internetwork Operating System S...

The GEIP and GEIP+ differ primarily in their performance. The GEIP+ provides up to 800 Mbps of aggregate throughput, while the GEIP performs at a 400 Mbps. Could you advise what does aggregate throughout exactly mean in this case? By the way, GEIP is...

Hi all,I have two Cat 6509 which have two Supervisor 2 modules each with MSFC for redundancy.They are doing HSRP for reliability..and Image version is c6msfc-ds-mz.120-7.XE1.and then suddenly the CPU utiliztion is 100 % for 30 minutes.Log follows...J...

I am having a strange problem. A couple of my users, are complaining of slow network. I checked the switches that they are on but there aren't hardly any errors or collisions. I checked for viruses,.etc.. on the machine but nothing. The one thing...

Hi all,I have got a Firewall that is doing intervlan routing (no dynamic routing involved). The connectivity is with 3 different interface into a 3550 switch (Just L2). Can I enable portfast on the switch interfaces?I am not seeing any issue with thi...

Is there a similar command (port storm-control) in CatIos? So that unicasts storms can be blocked at the port level. Thanks,Marcelo

Can I put an etherchannel-interface in a bridge-group together with an other physical interface, and assign the ip-address to the bridge-group? Does this effect performance?If I doesnt configure Etherchannel Load Balancing, is it balancing with sourc...