Other Network Architecture Subjects

Here is the setup:I have 2 LANs with 4 routers and many remote offices. Router A is on LAN1 connected to one side of the outsourced WAN via s0/0. Router B is on LAN1 connected to router C that is on LAN2 via a point-to-point link. Router D is on L...

I would like to permit others' trace pass through my router and display response time,but do not display my ip address.How to implement the purpose?

I have read many documents on CCO regarding QoS on various platforms but I would like a definative guide/recommendation for an AVVID network - Cisco CallManagers/IP Telephony/VoIP, Video and Data. AutoQoS seems to set various things up but it just d...

During the diagnosting of the IDSM-2 in my cisco Catalyst 6500 switch i receive the follwoing error message:%ONLINE-SP-6-INITFAIL: Module 5: Failed to synchronize Port asicany help would be greatly appreciated

Hi everybody.We have a situation where in we want to restrict a paricular ip-address and mac-address combination gaining access to the network. The network comprises of3548 XL(IOS 12.(5).WC5) at user end, which gets connected to a 4006 with sup-ii+42...

Can you please tell me what are the physicaladdresses or mac-addresses for the 50 ports of switch 2948G?i need topopulate values in RFC1213-MIB and IF-MIB to simulate the agent.i gotthis infoCompare:c2948-dc> (enable) show moduleMod Slot Ports Module...

Dear all,In Resource-Manager | Administration | Inventory | View Check Results - I have some devices listed as "Write Community - INCORRECT".These devices use a write community other than default.When I change the community-write-string ("change Attr...

I have a one 2611 and two 2621 routers that all the config-registers have a value of 0x3922 and when I change it to either 0x2102 or 0x2142 they change to a different 3900 value. The second problem I encountered was that in rom I can't use the tftdnl...

hi allit is possible to save ios versions from router and switches with ciscoworks2000 ?? running config and startup config is no problem !thanks in advance

Hi All, I had saw some post about 3550 voice vlan in this forum. Many people said that the voice vlan just can be configured in trunk mode as follow: int f0/1 mls qos trust cos switchport trunk encap dot1q switchport mode trunk switchport trunk nativ...

I'm trying to copy an IOS image (about 40meg) to Disk0: (Compaq pcmcia flasy) on the Sup720 on Cat60xx.I like to know the various options available for copying a large image to compaq flash.

Hi,I´d Like to know if any of the switches 2950 can do routing. At this time I have one 2950G 24 E1 with enhanced image, but I dont know if I can do the switch routes maybe changing the IOS or something.Thanks in advancedEF

Hi,I'm interested to do the following thing:If one ethernet port in a catalyst switch is going down to shutdown in the same time another port.Is this possible somehow ?Why I need this ?I have the following config:R1 --- SW --- R2The links are GE. If ...

Hi,We had an image in router 2600 which we thought of upgrading. As there is memory constraint, we deleted the image. But still the router was showing image deleted and the memory is not freed. We tryed squeeze command but it didn't work. Finally we ...