Other than being able to ping all remote sites from central site (hub & spoke scenario) for troubleshooting purposes, what would be the advantage of implementing multipt subinterfaces instead of point-to-point subinterfaces?
Is it normal for a port configured as an access port to respond to PVST multicasts recieved on this port. Surely this behavior should be reserved for Trunk ports?
Is there a way to set the threshold of the NVRAM memory instance of a switch differently from the other memory instances? I know it can be done per interface, but I can't get it to work for the memory. Any suggestions, or can it even be done?
I have a C4506 as Core switch, copules of C2924 as Distribution switch and dozens of C1924 as access switch. Few of the C1924 are casacaded using F0/27 to F0/26 of another C1924.I am encountering the following problem:1) For some of Canon photocopier...
I have a 3550 switch and I am wanting to look at the IP flows much like you can do on a router with issueing the show ip cache flow statement(after you have issue the ip route-cache flow statement on an interface. When I do this in my 3550 switch, I...
Hi,How can we monitor PRI on MRTG which is terminated on CISCO 3600 series Router?We have terminated the PRI line on controller card.and our ISDN users use this PRI.If PRI goes down, we come to know from the users that they are not able to connect.An...
Does RWAN have all functions like SNMS?So If i buy RWAN i will have all functions like in SNMS.As I can see in RWAN there is no Whats up Gold.Does any of RWAN modules have functions of What Up GOLD (network discovery,mapping,monitoring, allarm tracki...
I have 2 routers (A & B) sharing a neighbor relationship. If I set the bandwidth for the ethernet interface on router A to a value of '1', to modify the default route advertised to the B router, I still see a value of 1544 on the advertised router t...
HiThe forwarding bandwith for cat 2970 is given to be 28 or 24GBps.For cat 3750g it is given to be 32 Gbps.the forwarding rates is 38,7 MPPS for the two .So which are the differences between forw band and forw rates.?Are these two catalyst blocking ?...
