Other Network Architecture Subjects

Greetings!I am new to Switch monitoring. I have setup span in a 2900 cisco switch. The actual command i used is: "set span 2/1 3/25". But it is not giving the full traffic. Am i missing out anything?Thanks and Regards,Saifullah

Quick question...Reviewing a network configuration in which a Cat5500 w/rsm is in the core of the main site (roughly 150 remote sites, most over FR links). It's working fine, some issues but outside the scope, and configured properly IMO. My questi...

pls post me how ?I tried 2950T ------ 2950G and 2950G ---- 3550via trunk 802.1q trust cos , and input port uses cos 5use smartbit to pump traffic

Command "default-information originate" in isis enable L1L2 IS generates a 0.0.0.0/0 prefix in its Level-2 lsp.But what will happen if the L1L2 IS is unattached from backbone?dut1-----L2(LAN1)--------dut2 | | |______L1(LAN2)__...

Hi,I've got a new install of ITM 2.0 withITM 2 IDU 1.0GW Stats UtilIP Phone Helpdesk UtilIP Phone Info UtilI have all the media servers and phone-supporting switches without any problems.In the IP Info Util if I try to add a discovery schedule for ph...

I have a cisco 3640 Router and behind that i have four terminal servers. I want the Cisco Router is do a tcp load balancing on roud-robin fashion between these four terminal servers when connecting from systems that are in the other side of the route...

for some reason load balancing is not working the router is only using the 1Mbps link .....

I have a Cisco AS5300 Access Server that is currently connecting to two ISDN/23 (under a prime number and within the same hunting group). Remote users can dial into Corporate network without problem. Now, I plan to let users to dial out via this AS53...

h'mm ... I set the console password on a 3548:config tline console 0password xcxcxcI copied run to start and reloaded.But I didn't get propmted for a password when I'm connected to the serial port.I want to control access to the switch via the consol...

The DHCP configuration quide states: "If you choose not to configure a DHCP database agent, disable the recording of DHCP address conflicts on the DHCP Server"Perhaps I don't understand what the purpose of the "(no)ip dhcp conflict logging" command r...

i have a cisco router 1605 R series and i have configured my router with DHCP. when i type sh ip interface brief i see my public ip.i ping known public ip addreses i get replies with no problembut with my pc i can't ping any ip address outside and c...

I Have 3 sites, site A, B, C. A is HQ connected with FR to B and C. B is backup site. Usually B and C connect to the server located at A. In case the A FR and server is down C and A will access to B site. So they connect to B using different FR DLCI....

pls. help me guys!!!i have a problem with my cisco 1721 router i cannotfind the image only the rommon > prompt appeared. problems:"device does not contain a valid magic number.""boot: cannot open "flash:""boot: cannot determine first file name on dev...